Page 1 of 1
BIG SKY TOWER 60D - 5FT X 12FT (NON-BACKLIT)
2. Locate the Bottom and Side Extrusions:
3. Locate the Top and Side Extrusions:
1. Attach Split Connectors to Side Extrusions:
a. Remove the screw and insert split connector
into one end of the extrusion. Match like colored
numbers together. (e.g. 3-3, 4-4).
b. Tighten screw to lock it into place. Remove
the remaining screw from the connector.
c. Then slide the other extrusion onto split
connector. Make sure extrusions are ush
and tighten the screw to secure connection.
c. Connect horizontal extrusion to
the bottom of a vertical extrusion,
screw facing inward.
d. Connect bottom extrusions to-
gether and use torx key to tighten.
a. See colored numbers on each
extrusion piece. Match like colored
numbers together. (e.g. 3-3, 4-4).
a. See colored numbers on each
extrusion piece. Match like colored
numbers together. (e.g. 3-3, 4-4).
b. End Lock is already attached to
opposite ends of extrusion.
c. Connect horizontal extrusion
to the top of a vertical extrusion,
screw facing inward.
d. Connect the top extrusions to-
gether and use torx key to tighten.
b. End Lock is already attached to
opposite ends of extrusion.
SET UP INSTRUCTIONS 1/2
b. Insert Center Connector and align holes
with holes on extrusion.
a. Remove screws from Center Connector. c. Repeat to connect other extrusion to make
one long piece.
4. Build Support Struts:
