Page 1 of 2
SET UP INSTRUCTIONS 1/2
2. Locate the Bottom and Side Extrusions:
3. Locate the Top and Side Extrusions:
1. Attach Split Connectors to Side Extrusions:
a. Remove the screw and insert split connector
into one end of the extrusion. Match like colored
numbers together. (e.g. 3-3, 4-4).
b. Tighten screw to lock it into place. Remove
the remaining screw from the connector.
c. Then slide the other extrusion onto split
connector. Make sure extrusions are ush
and tighten the screw to secure connection.
c. Connect horizontal extrusion to
the bottom of a vertical extrusion,
screw facing inward.
d. Connect bottom extrusions to-
gether and use torx key to tighten.
a. See colored numbers on each
extrusion piece. Match like colored
numbers together. (e.g. 3-3, 4-4).
a. See colored numbers on each
extrusion piece. Match like colored
numbers together. (e.g. 3-3, 4-4).
b. End Lock is already attached to
opposite ends of extrusion.
c. Connect horizontal extrusion
to the top of a vertical extrusion,
screw facing inward.
d. Connect the top extrusions to-
gether and use torx key to tighten.
b. End Lock is already attached to
opposite ends of extrusion.
RESORT EXTRUSIONS
BIG SKY TOWER 60D 4FT X 14FT BACKLIT
PRODUCT CODE: BIGSKYT60D4X14-LLFRM
4. Attach Light Hooks:
a. Eye Hooks: Insert light hooks into the
groove in one end of the extrusion.
b. Slide the light hooks into the groove and
place them in the center. Tighten Hook.
c. Make sure light hooks are place far
apart for hooking the LED Ladder Lights.
