F-3926 3 of 6 3-23-04
2-7233
PARTS LIST - MOUNT KIT
ITEM Part No. DESCRIPTION QTY.
1 52004 MID MOUNTING ASSEMBLY, Left 1
2 52005 MID MOUNTING ASSEMBLY, Right 1
3 52017 FRONT MOUNT ASSEMBLY 1
4 52138 YOKE ASSEMBLY, with Decal 1
5 43395-6 SPACER, Tube 5/8 YDP 4
6 42672-15 SCREW, Cap, 16MM-2.00MM x 40MM 8
7 42672-43 SCREW, Cap, 14MM-2.00MM x 60MM 4
8 42672-46 SCREW, Cap, 14MM-2.00 x 40MM 4
9 42672-51 SCREW, Cap, 14MM-2.00 x 35MM 8
10 41837-7 WASHER, Lock, 5/8 YDP 8
11 41840-8 NUT, Lock, 3/4-10 YDP 4
12 41838-7 SCREW, Cap, 3/4-10 x 2.50 YDP 4
13 39240 DECAL, “WARNING, Do Not Use For Towing” 2
14 42502-11 WASHER, Flat, 9/16” 4
15 41837-6 WASHER, Lock, 9/16” 12
INSTALLING YOKE ONTO LOADER
WARNING: Be sure to support loader
using an overhead hoist. Boom may fall
causing serious personal injury permit.
Install yoke assembly (4) using 3/4 x 2-1/2 cap screws
(12) and 3/4 lock nuts (11). Install rear cap screws first,
then swing yoke into position and install front cap
screws.
IMPORTANT: Install 3/4 x 2-1/2 cap screws (12) from
the inside with lock nuts (11) on the outside of yoke.
NOTE: Hardware connecting yoke to loader side
frames should be snug, but do not torque completely.
After loader has been mounted to tractor and aligned
with mid mounting brackets and front mounting
brackets, torque hardware to 239-262 ft.-lb.
INSTALLING LOADER TO MOUNTING
BRACKETS
WARNING: To avoid injury during
installation of quick attach loader, do not
permit bystanders within ten feet of loader.
1. Remove hardware which secures loader to pallet.
Using overhead hoist, lower loader from vertical
shipping position to horizontal position (use scraps
of cardboard to protect paint).
2. Reposition overhead hoist by looping nylon strap
around yoke near loader side frames at balance
point of loader.
3. Using overhead hoist, raise loader until side frame
uprights will clear front tires. Remove lock nut and
washer from loader hinge and swing each hinge
open..
Fasten rear
bolt first.
Swing yoke
into position.
Balance point
of loader
