Richelieu ERGO TOPPER III User manual

INSTALLATION GUIDE
CAUTION
-8-
WARNI NG
!
CAUTION
Please read all instructions carefully before using this product.
Retain this manual for future reference.
The specifications of this product may vary slightly from the
illustrations and are subject to change without notice.
THE TOPPER III SIT-STAND DESKTOP WORKSTATION
500S2S90

-7-
-2-
AC
x1
B
x1
x8 x4
x1
x1
x2
Accessory Package List
TOOLS
ASSEMBLY STEP 5
CAUTION
Cable
Nylon ties
Technical Data
A: 3~15kg
B:<=2kg
A+B=3~15kg
A
B
Please do not exceed the
maximum bearing weight
WARNING
150~500
580
566
680
590
610
≤
740
≤
Note: The drawings below are only for reference and may be slightly
different with the actual product. If any tools are missing or installation
problems, please contact customer service.

-3-
-6-
ASSEMBLY STEP 4
Please put the devices onto the top of the workstation.
CAUTION
ASSEMBLY STEP 1
Please take the packaging carton apart, take
out the product and place it on the table.
CAUTION
+
Please place the product properly, or it may cause injury or damage.

-5-
-4-
ASSEMBLY STEP 3
WARNING
ASSEMBLY STEP 2
cTighten
a
d
b
a: Attach the decorative cover to the connecting arm.
b: Connect the junction plate and keyboard tray by 8 screws
and use screwdriver to fasten.
c,d: Hang the junction plate on the knob assembly and tighten.

-5-
-4-
ASSEMBLY STEP 3
WARNING
ASSEMBLY STEP 2
cTighten
a
d
b
Please do not put hands near the supporting bars, as they change
during adjustment and may cause injury.
Based on requirement, press the handle grips both sides
simultaneously, and adjust the workstation to the proper height.

-3-
-6-
ASSEMBLY STEP 4
Please put the devices onto the top of the workstation.
CAUTION
ASSEMBLY STEP 1
Please take the packaging carton apart, take
out the product and place it on the table.
CAUTION
+
Please ensure all equipment is on the table, and not extending out
over the edge, or it may cause injury or damage.

-7-
-2-
AC
x1
B
x1
x8 x4
x1
x1
x2
Accessory Package List
TOOLS
ASSEMBLY STEP 5
CAUTION
Cable
Nylon ties
Technical Data
A: 3~15kg
B:<=2kg
A+B=3~15kg
A
B
Please do not exceed the
maximum bearing weight
WARNING
150~500
580
566
680
590
610
≤
740
≤
Adhesive buckle helps to keep the cables tidy and clean Please leave
enough cable length for height adjustment function.

INSTALLATION GUIDE
CAUTION
-8-
WARNI NG
!
CAUTION
Please do not put hands near the
supporting bars, as they change during
adjusting and may cause injury.
Please make sure all installed equipment does
not extend over of the edge, or it may cause
injury or damage.
Adhesive buckle helps to assist in cable
management. Please leave enough length of
cable for height adjustment function.
Please first adjust it to the highest, then remove
equipment to avoid harm or damage.
Please move unit with two people, or damage
may occur.