RINSEKIT HYPERHEATER User manual

THE
RINSEKIT
HYPERHEATER
UNDERSTANDING YOUR APPLIANCE
Scan QR code
for how to use
videos.

UNDERSTANDING
THE HYPERHEATER

HYPERHEATER
How to Operate Directions
12
34
Carefully insert propane into
gas regulator.
Propane NOT included.
Attach gas regulator to back of
the heater.
Connect propane power cord
into power inlet.
Connect power cord into RinseKit
PRO 12v outlet. NOTE: (You can also
plug into vehicle 12v outlets)
See next page

Remove nozzle from your RinseKit
and connect to the water inlet via
quick connect. Make sure the
valve is in the ON position.
Connect included heater shower
head to tap outlet. Make sure the
valve is in the ON position.
Press power button on
your RinseKit.
Press ON/OFF button on
heater.
5 6
7 8
Use Switch on shower head
to turn the water ON or OFF.
Use the gas valve to turn the heat up
or down. There will be a slight delay
as the heater heats up the water.
910

IMPORTANT INFORMATION
We recommend using 16oz
consumer grade propane
tanks to operate the
HyperHeater.
For the optimal shower
temperature, start with the
gas valve in the center
between LOW and HIGH.
Adjust temperature as
needed.
⚠ IMPORTANT:
Remember to disconnect the
power cord from the heater,
even when not in use, to avoid
draining the battery of the PRO.

When you shut off the nozzle, the
hot water inside the heater may
cause the cut out light to
illuminate.
Keep shower nozzle in ON position
during use. Turning the nozzle OFF and
ON repeatedly will cause overheating
and will trigger cut out warning.
The high temp cut out (triggered at 106
degrees F) is designed to prevent the
water from getting too hot.
To reset simply spray the nozzle for 5
seconds. You will see the temperature
drop on the display and the cut out will
automatically reset in 10 seconds.
ADDITIONAL INFORMATION

When done using the heater,
disconnect the gas regulator from
the heater.
STORAGE
Disconnect the propane from the
regulator.
Disconnect the RinseKit and the
shower head then dump out any
water left inside the heater by
tipping the heater backwards.
Never store the heater on its side.

CUSTOMER SERVICES
CONNECT WITH US
For questions and assistance:
800-613-5764 | [email protected] | RinseKit.com
Your HyperHeater comes with a warranty. For more
information, visit the Warranty Tab at www.RinseKit.com.
*Proof of purchase is required for warranty claims.
Don't forget to tag us on social media for a chance to be
featured on our RinseKit in Action page!
Use #RinseKit when sharing your post.
@rinsekit @rinsekitusa

IMPORTANT
SAFETY WARNINGS

800-613-5764