ROADWORX 4120B User manual

ö
+
#
,
$
& ' ()*
%
-./0123
#
$
$
$
$
öö
#
% %
&
&
&
&
&
&
'
''
'
4120B
M6×20 M6×25 M6×30
2 ×
2 ×
5 ×
2 ×
6 × 4 ×
10 × 24 × 10 ×
10 × 14 × 12 × 26 × 8 ×
10 ×
20 ×
4 × 8 ×
EN
Features
 Keyboard stand for four keyboards with a maximum
width of 120 cm
 Four freely height-adjustable rests
 Eight freely tilt-adjustable holders
 Rest inside width: 120 cm
 Holder length: 69.5 cm (rest 1)
56 cm each (rests 2, 3, and 4)
 Material: aluminium, plastic
 Load capacity: max. 35 kg (rest 1)
max. 10 kg (rests 2, 3, and 4)
 Dimensions (W × H × D):
1292 mm × 1391 mm × 700 mm
 Weight: 16 kg
Assembly material
Overview

Thomann GmbH · Hans-Thomann-Straße 1 · 96138 Burgebrach · Germany · www.thomann.de
DocID: 547968_22.02.2023
,
,
-
-
+
+
+
+
,
,
+,
Assembly instructions
Intended use
This product is intended to be used as keyboard stand. Any other use is considered to be
improper and may result in personal injury or property damage. No liability will be
assumed for damages resulting from improper use.
Danger for children
Ensure that plastic bags, packaging, etc. are disposed of properly and are not within reach of
babies and young children. Choking hazard! Ensure that children do not detach any small
parts from the product. They could swallow the pieces and choke! Never let children
unattended use the product.
Danger of tipping on unsuitable ground
If placed on soft or uneven ground, the product may overturn and cause injuries and
property damage. Place the product on at and solid surfaces only.
Danger of tipping during loaded transport
If the product is moved without removing the loaded equipment, the product may tip
over and cause injuries and property damage. Remove all equipment from the product
before moving the product.
Risk of injury to the hands
When assembling and screwing the individual parts, pay attention to sharp edges on
tools, screws and components.
Danger of pinching
When assembling the product, pay attention not to squeeze your ngers/hands.
Possible staining
The plasticiser contained in the rubber feet of this product may possibly react with the
coating of your surface and after some time cause permanent dark stains. In case of
doubt, do not put the rubber feet directly on the surface and use a suitable underlay if
necessary, i.e. felt-pad oor protectors or similar.
For the transport and protective packaging, environmentally friendly materials have
been chosen that can be supplied to normal recycling. Ensure that plastic bags,
packaging, etc. are properly disposed of. Do not just dispose of these materials with your
normal household waste, but make sure that they are collected for recycling. Please
follow the notes and markings on the packaging.