Rockler 48426 User manual

1
Steel Router Table Leg
Assembly Instructions
1
PARTS list - Steel Router Table Leg Set Quantity
1 32" Legs w/ mounting holes 2
2 32" Legs 2
3 251⁄2" x 2" Upper Stretchers 2
4 251⁄2" x 3" Lower Stretchers 2
5 171⁄2" x 2" Upper Side Stretchers 2
6 171⁄2" x 2" Lower Side Stretchers 2
7 Leveling Feet 4
8 #8 5/16-18 Bolts 32
9 #9 5/16-18 Nuts 32
1 2 2
4
4
3
3
6
6
5
5
7
8
9

2
Install the Levelers
Remove the top hex nut from each of the leveling feet;
insert the levelers through the holes in the square base of
each of the legs. Then replace the hex nut you removed
using a 3/4" wrench.
Stand Assembly
1. Begin assembling your stand by attaching one Lower
Stretcher (4) and Upper Stretcher (3) to the 32" Legs
with mounting holes (1) and 32" Leg (2). Be sure to
orient the short lip on the Stretchers (3 and 4) toward
the top.
Note: Use just one #8 5/16"-18 Bolt (8) and one
 #95/16"-18Nut(9)atrst,usingthesquareholeclosest
to inside corner of the legs. Leave the adjacent hole
open for now.
2. Repeat step 1 with the remaining Lower and Upper
Stretchers (3 and 4) and the remaining Legs (1 and 2).
48426
Rev 06/15
Distributed by Rockler Companies, Inc.
©2015 Rockler Woodworking and Hardware
3. Lay one of the assemblies you have just completed
 ontheoorandattachtheUpperSideStretchers(5)
 andLowerSideStretchers(6)totheLegs(1and2),
still just using one #8 5/16"-18 Bolt (8) and one
#9 5/16"-18 Nut (9) for each set of holes.
4. Carefully lay the second assembled side of the router
stand on top of the four outstretched side stretchers you
 justattached.Again,useone#85/16"-18Bolt(8)and
one #9 5/16"-18 Nut (9) for each set of holes.
5. Stand your completed Router Table base upright and
use a square to adjust the angles to 90°. Using a 1/2"
socket install the remaining bolts and nuts and tighten.
1
23
4
5
1
2
3
4
5
6
6
7
7
7
7