RocwooD RWFAS3 User manual

RocwooD
3 Ton
FOLDING AXLE STAND
INSTRUCTION MANUAL
PLEASE READ & RETAIN
RWFAS3

SAFETY WARNINGS - ALWAYS READ BEFORE USE
• Read these instructions carefully before use.
• Do not exceed the axle stands maximum
load (1.5 ton each/ 3 ton per pair), The
vehicle weight will be in the owners manual.
• Use only as specified in this manual.
• NEVER let children play in or around a vehicle
that is on axle stands.
• ALWAYS make sure that before you work
below the vehicle, a responsible person is
aware in case of injury or accident.
• Do not use more than one pair of axle stands.
• Replace the warning label if it becomes
unreadable.
• Use only on a hard, flat surface for example
concrete.
• Make sure that you chock all the wheels that
remain on the ground.
• Make sure that the supported vehicle cannot
move.
• Set each axle stand below an appropriate
point on the vehicle - See your vehicle
owners manual for advice.
•Take care when using the axle stands on a
three-wheeled vehicle or trailer.
• Upper and lower columns are to be used as a
pair as supplied.
• Use stands as a matched pair to support one end of a vehicle
only.
• For your safety, do not modify these axle stands
WARNING: USE ONLY ON A HARD, FLAT SURFACE FOR EXAMPLE CONCRETE.
WARNING: NEVER WORK UNDER A VEHICLE SUPPORTED ONLY BY A JACK.
WARNING: AFTER LIFTING THE VEHICLE, SUPPORT IMMEDIATELY WITH
PROPERLY RATED AXLE STANDS.

USING THE AXLE STANDS
WARNING: BEFORE USE, MAKE SURE THAT THERE IS NO DAMAGE TO ANY PART
OF THE AXLE STAND, IF THERE IS, DO NOT USE THE AXLE STAND.
WARNING: DO NOT EXCEED THE RATED LOAD OF 3 TON (PER PAIR).
WARNING: USE ONLY ON A HARD, FLAT SURFACE, E.G. CONCRETE.
1. Refer to the vehicle handbook for
the correct jacking procedure and
location of the support points.
2. Fully spread the three legs.
ADJUST THE AXLE STAND
1. Remove the locating pin (if fitted).
2. Raise the upper column to the
required height and insert the
locating pin into the lowest hole
visible.
3. Insert the retaining pin into the end
of the locating pin to secure it in
position.
4. Position the axle stand under a
suitable supporting point. See your
vehicle manual for the location.
LOWERING THE VEHICLE
1. Slowly lower the vehicle onto the
centre of the saddle
WARNING: DO NOT LOAD THE STANDS OFF CENTRE. FAILURE TO HEED THIS
WARNING MAY CAUSE DAMAGE, INJURY OR LOSS OF LIFE.
TO REMOVE THE AXLE STANDS
1. Raise vehicle clear of the axle stands.
2. Remove stands.
3. Ensure that all tools, equipment and personnel are clear before carefully
lowering the vehicle to the ground.

SPECIFICATION
Capacity
3-Ton
Minimum Height
240mm
Maximum Height
360mm
N.W/G.W
4/4.3kg
Number of Height Positions
4