• Before using this stand, carefully read the sections entitled: “USING THE STAND SAFELY” and “IMPORTANT NOTES” (separate sheet). These
sections provide important information concerning the proper operation of the stand. The manual should be saved and kept on hand as a
convenient reference.
• Make sure that another person is on hand to help with the assembly and setup.
• Assembly and adjustment must be performed on a flat and level surface.
• Be careful not to pinch your fingers when setting up the stand.
• Do not move the stand with the keyboard resting on it. Doing so may cause the keyboard to overturn or fall.
• If any of the bolts that are not involved in the assembly procedure have become loose, use a commercially available allen wrench (5 mm) to
tighten them.
Before you begin assembly, check to make sure that you have all of the parts.
* For details on using the knob bolts and headphone hook, refer to
the owner’s manual that came with the piano.
* You’ll need to provide a Phillips (+) screwdriver.
* In the interest of product improvement, the specifications and/or
appearance of this unit are subject to change without prior notice.
1
Use the included Allen wrench to remove the bolts
marked (A) and washers.
2
Raise the support columns as shown in the illustration,
and while holding the columns in place, use the
previously removed bolts (A) and washers to fasten the
columns to the leg.
3
Lay the stand on its back.
4
Use the included Allen wrench to remove the two bolts
marked (B) and their washers, then swing the arm to the
position shown in the illustration.
Caution
Check the parts
(1)
(2)
(3) (4)
(5)
(6)
(7)
(1) Stand 1
(2) Support bar (with bolts) 2
(3) Cable cover 2
(4) Stud screw 4
(5) Allen wrench 1
(6) Knob bolt 4
(7) Headphones hook 1
Assembly
(A) (A)
Leg
Arm
Leg
Support column (A)
Washer
(B)
Arm
5
Use the included allen wrench to remove the bolts (C)
and washers that are attached to the support bars.
6
Using the bolts (C) and washers that you removed in step
5, loosely fasten the support bars to the leg.
7
Raise the arm, and using the bolts (C) and washers you
removed in step 5, fasten the support bars to the arm.
8
Firmly tighten the bolts (C) that you lightly fastened in
step 6.
9
Fasten the arm using the two bolts (B) and washers you
removed in step 4.
10
Place the stand upright.
11
Turn the adjusters located at the positions shown in the
illustration so that the stand is horizontal relative to the
floor.
Adjust them so that the stand does not lean or wobble.
Attaching the cable covers allows you to improve the appearance of your
setup by neatly organizing the cables connected to the keyboard.
1
Use a Phillips (+) screwdriver to attach two stud screws to
each support column.
2
Hook the two holes in each cable cover onto the two stud
screws you attached to each support column.
* If you have difficulty attaching the cable covers, temporarily loosen
the screws, and re-tighten them after you’ve attached the cable
covers.
The included allen wrench can be inserted into the holder shown in the
illustration. Stored here, it can be removed whenever needed.
(C)
(C)
(C)
Washer
(C)
Washer
(C)
(C)
(B) Washer
Attaching the cable covers
Storing the allen wrench
Adjuster
Holder
Copyright © 2008 ROLAND CORPORATION
All rights reserved. No part of this publication may be reproduced in any form without the written permission of ROLAND CORPORATION.
Owner’s Manual
