rollease acmeda AUTOMATE ARC READER User manual

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
•Consult the dealer or an experienced radio/TV technician for help.
Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s
authority to operate the equipment.
STATEMENT REGARDING FCC COMPLIANCE
REGULATORY COMPLIANCE
Do not dispose of in general waste.
Please recycle batteries and damaged electrical products appropriately.
2014/35/EU The Low Voltage Directive
2014/30/EU The Electromagnetic Compatibility Directive
2014/53/EU The Radio Equipment Directive
Rollease Acmeda declares this equipment is in compliance with the essential
requirements and other relevant provisions of the following directives:
Plug USB power adapter into a power outlet.
Plug the ARC Repeater into the USB power adapter.
A blue LED on the ARC Repeater will be visible
when the power is switched on.
Only use Rollease Acmeda USB power adapters with ARC Repeater.
Using other power adapters/power sources may adversely affect ARC
Repeater performance and should be avoided.
ARC Repeater is plug and play. No setup required.
Press any button on a Rollease Acmeda remote
control. The blue light on the ARC Repeater will
flash 3 times. This means the ARC Repeater is
transmitting the signal.
ARC REPEATER
QUICK START GUIDE
rolleaseacmeda.com
1
2
3
WARNING
NOTE
40m/131ft 40m/131ft
OR
40m/131ft 40m/131ft
OR
Maximum of 2 ARC Repeaters can be used in one project
Don’t cover the ARC Repeater with a metal shield
LED LIGHT
IMPORTANT

REGION AU EU UK US
PART MTPS-USB5-1000AU MT03-0301-069009 MTPS-USB5-100EU MT03-0301-050002 MTPS-USB-BK MT03-0301-069008
40m/131ft 40m/131ft
OR
40m/131ft 40m/131ft
OR
40m/131ft 40m/131ft
OR
40m/131ft 40m/131ft
OR
40m/131ft 40m/131ft
OR
40m/131ft 40m/131ft
OR
40m/131ft 40m/131ft
OR
40m/131ft 40m/131ft
OR
40m/131ft 40m/131ft
OR
40m/131ft 40m/131ft
OR
40m/131ft 40m/131ft
OR
40m/131ft 40m/131ft
OR
QSG-MT02-0401-069007 v4.2 APRIL 2019
The Rollease Acmeda ARC Repeater can extend the RF range of operation for ARC-enabled
products by up to 40m (131ft).
40m/131ft 40m/131ft
OR
NOTE: RF source can be PULSE or any ARC Remote Control or Sensor.
LED STATUS
On Power On
Flashes x 3 Transmitting a remote control, motor or sensor RF433 MHz signal
Flashes x 1 Transmitting a Pulse hub RF433 MHz signal
INTERFACE USB
WORKING VOLTAGE 5±0.2 V DC
POWER SUPPLY USB POWER ADAPTER
RADIO FREQUENCY 433.92MHZ
RADIO DISTANCE OF
OPERATION
40m
131.23ft
RECEIVER SENSITIVITY ≥ -65 dB
TRANSMITTER POWER 3 ~ 3.5 dBm
RF PROTOCOL ARC
RF MODULATION FSK
SAFETY CERTIFICATION TUV
RF CERTIFICATION RTTE
ENVIRONMENTAL
CERTIFICATION ROHS
ELECTROSTATIC
DISCHARGE
4KV (Contact discharge)
8KV (Air discharge)
COLOR WHITE
INDICATOR BLUE LED
IP CODE IP20
WEIGHT
0.01kg
0.022lbs
WORKING
TEMPERATURE
-5 ~ 50 °C
23 ~ 122 °F
WORKING HUMIDITY < 80%
STORAGE
TEMPERATURE
-10 ~ 65 °C
14 ~ 149 °F
INSTALLATION RANGE LED LIGHT INDICATION
SPECIFICATIONS
ROLLEASE ACMEDA USB POWER ADAPTERS