Rollersafe RS SKATE Specification sheet
Get started / User Manual
RS SKATE/RS CLASSIC
2
3
4
5
6
7
1
10
8
9
Grip Controller Unit
Brake Controller Unit
Charging Latch (Rottefella tool provided)
Click-On Mud Guard
Slide-On Binding (Rottefella tool provided)
Brake Caliper
Brake Pads (Only use RollerSafe approved Brake pads)
Casing (Skate/Classic)
AC Adapter/ 2x USB cables
RollerSafe APP for Android/Apple Download: www.rollersafe.no
1
2
3
4
5
6
7
8
10
9
1. Ensure that you set required brake force (mobile app); brakes should give soft
speed reduction, WITHOUT BLOCKING the wheels
2. Always test the brakes on each ski BEFORE start and BEFORE you go downhill
3. Practise braking having controlled speed, outside traffic. Ensure you find good
balance on your body when braking in different speed and situations (recom-
mended to put one ski in front (see picture), and brake with this ski. Use the
other brake as supplement if needed
4. Safe speed reduction implies good control of your balance at any time; to
avoid dangerous situations, you should reduce speed early
HOW TO USE YOUR ROLLERSAFE
AVOID AGRESSIVE BRAKING - BLOCKING WHEELS AND SUDDEN STOP CAN LEAD TO INJURIES!
1. Download the RollerSafe APP
2. Open the USB/Charging Latch with the Rottefella tool
3. Charge the ski with RS Adapter (9)
4. Log in to RollerSafe APP and find your skis under info page
5. Follow instructions:
- adjust preferred brake force
- see battery status
- auto firmware update
- user manuals video
- webshop
AVOID AGRESSIVE BRAKING - BLOCKING WHEELS AND SUDDEN STOP CAN LEAD TO INJURIES!
HOW TO USE THE ROLLERSAFE APP?
A. BATTERY CHARGING
Open Charging Latch (#3), insert USB Charging Cable (#9). Charging takes ~3 hours from
0-100%. LED in USB port blinks green during charging
B. BRAKE FORCE SETUP
Connect Mobile App (#10) when Charging Cable is inserted.
Adjust desired brake force according to weight/user profile
C. START UP SKIS
Push and hold for 2 sec start button on Brake Controller Unit (#2)
Wait 10 sec while brake automatically calibrates (LED light blinks RED)
LED light blinks GREEN every 5 sec, ready to use
D. SETUP GRIP CONTROLLER
Remove top plug from your ski pole
Insert RS Grip Controller plug (#1), ensure to fix it (taps on each side)
Slide on Grip Controller Unit, ensure to fix the tap (up)
E. SYNC SKI & GRIP CONTROLLER
For each ski: Hold Grip Controller close to Brake Controller. Push start button and trigger,
hold for 5 sec. Ski and Grip Controller will immediately connect.
Repeat for the other Brake C./Grip C.
Get Started – User Manual
F. POWER OFF
Brake Controller automatically POWER OFF after 2 hours since last brake activity. Manual
power off: Push and hold start button for 10 sec (LED stops blinking)
G. MAINTENANCE
Ensure cleaning your skis after use; remove water, gravel/dirt. Use a cloth and small brush
H. STORAGE
Safely store your RollerSafe skis and Grip Controllers in the RS Travel Case (#8)
Bring extra mud gards, wheels, spikes, Unbraco® and charging cable in the travel case
NOTE!
Some of the setup operations (battery charging, brake force setup and sync) will not be
required for each trip, however, we strongly recommend to repeat these operations to
ensure right setup for each user and for detection of any errors prior to use
This manual suits for next models
1
Table of contents
