Rooboost RB-1500 User manual

User Manual
Ultra Safe Jump Starter & Power Bank
RB-1500
Please read this user manual thoroughly before using the product.

Copyright © 2019-2020, Rooboost, Australia. All Rights Reserved.

GETTING TO KNOW YOUR JUMP STARTER
9
9.a
9.b
11
11.a
11.b
13
1
2
3
4
5
6
8
7
6
9.c
10
12
1.
2.
3. Jump Start Socket
4. Output1: USB 5V/2.1A
5. Output2: USB Quick Charge 5V/3A, 9V/2A,
12V/1.5A
6. LED Light: Steady Torch, SOS Signal Flash,
Strobe
7. Input/Output3: USB Type-C 5V/3A
8. Output4: DC 12~16.8V/10A
9. Smart Jumper Cable
a. Jumper Clamp
b. Jumper Connector
c. Jumper Cable Display
10.
11. USB Type-C Charging Cable
a. Type-C Connector
b. USB Connector
12. SAA Power Adapter
13.

CHARGING THE RB-1500
•
use.
•
•Follow the bellow steps to charge the RB-1500.
a. Connect Type-C connector of charging cable into jump starter input port.
b.
lighter adapter (5V/3A).
c.
OPERATION & HOW TO USE
•It is recommended to charge the RB-1500 at least once a month in order to
•
while it is hot.
a
b
c
a
b
c
7

HOW TO JUMP START A VEHICLE
•
25% charged.
•
•
•
metal parts.
•Follow the bellow steps carefully to jump start your vehicle.
1. Connect the jumper connector (blue) into the RB-1500 jump start socket.
Wait for jumper cable display to go into stand-by mode. When in stand-by
2.
If the jumper cable display shows voltage without any warning or alarm beeps, it
9

3. Start your vehicle engine. If the vehicle does not start within 3 seconds, stop
4. Once you have successfully started your vehicle, unplug the jumper connector
from the RB-1500 within 30 seconds.
5.
10

Display View
LED Display Buzzer Warning
1. / 1. Jump starter voltage is low. Use bigger
capacity of jump starter.
2. /
2. Disconnect smart jumper cable from
re-connect appropriately.
3. Buzzer is Long
3. Smart jumper cable is damaged, stop
using it and carefully store in a safe place.
Contact Rooboost customer support.
One beep per
second
The jump starter voltage is low. Charge
the jump starter at least more than 25%.
One beep per
second
Ensure that the jumper clamps are
terminals.
2. Cables aren’t connected properly.
connect again properly.
One beep per
second
Disconnect the jump starter within 30
One beep per
second
T
Allow the jump starter to cool in a cooler
environment.
Buzzer is long
Jump starter is over voltage or damaged.
Stop using it and carefully store in a
safe place. Contact Rooboost customer
support.
TROUBLESHOOTING
[Table 1.1]
11
Smart Jumper Cable Normal/Abnormal Display Status

using it and contact customer support at [e-mail] with your order
number.
DEFECTIVE PRODUCTS & RETURNS
What is Not Covered:
•Using your jump starter for commercial purposes or anything other than normal
•Using your jump starter outside of Australia.
•Accidental damage or faults caused by neglect, misuse, vandalism and abuse.
•
•Unsupervised use by children under the age of 18.
•
authorised agent.
•
This warranty is not transferrable.
Rooboost is not responsible or liable for any damages, losses or inconveniences
caused by product failure or accidental damage or faults caused by not following the
Please email at [e-mail] with any further inquiries about Rooboost
warranty or to ask about making a warranty claim. You must contact us within your
warranty period for your claim to be eligible.
Customer Support:
Yasin Pty Ltd.
PO Box 2, Ermington 1700, NSW Australia
www.rooboost.com.au
[e-mail]
Please provide your order number when you contact customer support.
CUSTOMER SUPPORT - AUSTRALIA
14

www.rooboost.com.au
V1.0720
[e-mail]