Page 5
Signal Cable
When routing the signal cable from the FPD
junction box to the tuner location, note the
cable has different connectors on each end. The
silver D-9 connector goes to the FPD, while the
molded RJ-4 connector goes to the tuner
module. Since the D-9 is larger than the RJ-4 ,
you way want to take this into account when
routing the cable through tight spots.
IMPORT NT: The RJ-4 connector has a locking
plastic tab. This tab is usually protected by a
molded rubber cover built into the cable. However,
if too much force is used when routing the cable
through a tight spot, it is possible for this tab to
hang up. If the installer uses too much
force in this situation, the tab could break. Use
care when routing cables through tight spots.
Power dapter Cable
Plug the power cord into a 110V 60 Hz AC outlet.
The system consumes about 12 watts while in
use.
IMPORT NT: Ensure that this power cord is
routed safely and in accordance with any local
regulations.
Coaxial Cable
Screw the threaded coaxial fitting onto the
threaded fitting on the tuner module. Do not kink
the coaxial cable, and avoid sharp bends, which
places stress on the connectors.
2 About your Milan (cont.)
