Roundshot seitz Livecam Generation 3 User manual

Installation
Manual

Ferrite beads are used in electronic circuits to suppress interference, noise,
crosstalk, and other high-frequency disturbances from supply voltage lines,
data signal lines,and ground planes.

•
•
•
•
•
•
•
•
•
•

Very important: The mast must be connected by cable (yellow/green) to the
ground.

•Please provide the following network data to Roundshot prior to shipping:
•IP through DHCP (automatically assigned by switch/router/network)
•IP fixed
•If fixed, please provide: IP, subnet mask + gateway
•
•

•Please confirm to Roundshot prior to shipping that the camera will be
connected through wifi or through 4G.
•The camera will be shipped with a standard fixed IP (192.168.1.80) for direct
connection and configuration (connection to wifi, connection to mobile
network)
•

Very important: The mains adaptor casing must be connected by cable
(yellow/green) to the ground.

•
•
•
o
o
o
100cm
(40
inches)
Very important: The lightning protection box and the mast must be connected
by cable (yellow/green) to the ground.

Very important: The mast has to be grounded.
When installing the lightning protection the box does not have to be opened.
Attach the box to the mast and connect the cables.

•
•
•
•

•
•
•
o
o
o
o

Once the Uploader is activated with an upload password, it will automatically
be set as access password to the camera.
If the upload configuration of the Livecam has already been prepared by
roundshot prior to shipping, please contact roundshot to obtain this password.

•
•

•