RTA Techni Mobili RTA-B001N User manual

MODEL RTA - B001N
MODEL RTA-B001N

Spanish
Gracias por comprar uno de nuestros productos.
Por favor lea cuidadosamente las instrucciones de ensamblaje antes de
instalar la unidad.
Por favor guarde este manual para referencias futuras.
INSTRUCCIONES DE ENSAMBLAJE.
MODELO RTA - B001N
MODELO RTA-B001N

RTA-B001N
DIMENSIONS
MAXIMUM WEIGHT CAPACITIES
DO NOT exceed this limit
Please use care and good judgement
when placing objects on wood surface
Product Size: 29"W x 23"D x 31~44.5"H
Lowest position
Highest position
31
18
29
13"
13"
26"
23"
44.5"
4.5"

P.4

30mm
30mm
35mm
35mm
P.5

P.6
X 1 SET
X 1 SET
X 4 X 4

P.7
Use screws (A) to affix the Protection Rails (3) from the back side of Big
Panel (1). If entire holes are not visible, carefully use the screwdriver to
perforate holes through the laminate.

P.8
Use screws (A) to affix the Protection Rails (4) from the back side of Small
Panel (2). If entire holes are not visible, carefully use the screwdriver to
perforate holes through the laminate.
Use screw (B) to affix the Big Support (5) to the back side of Big Panel (1).
Place all screws on the board and do not tighten completely until all
screws are in place.

P.9
Use screws (B) to affix the Small Panel Support (6) to the back side of Small
Panel (2). Place all screws on the board and do not tighten completely until
all screws are in place.

Misaligned Aligned
P.10
Ensamble la Estructura T (9) con la Estructura Vertical (8). Poner
atencion que el Pin debe quedar alineado con los huecos.