RYTEC TERMINATOR DGS1500 User manual

TERMINATOR
4.7 INCH CHIPPER SHREDDER
  
ASSEMBLY GUIDE
 
  

   

CEA □
DGS1500

This machine has been developed and designed
for the purpose of chipping wood up to the size
of 120mm, it is not suitable to insert any other
type of material into this machine.
Please make sure all wood that is passed through
this machine is natural and organic i.e there is no
screws, nails or any other debris embedded in the wood.
The tow bar is to be connected to a ball joint connector
only.
Tow vehicles must have 4 wheels and be stable. This
can only be towed UP TO A MAXIMUM OF 50MPH
on public roads and the towing vehicle must have the
required towing capacity to tow this machine (this will
be outlined in the vehicle manual)
DGS1500 Intended use statement
You must read below before operating this machine

Crytec Limited
Declaration of Conformity
1. Product Model / Type:
a. Product: Wood Chipper
b. Model:
2. Manufacturer:
a. Name: Crytec Limited
b. Address: Unit 1C Upper Mantle Close, Chesterfield S45 9ED, UK
3. This declaration is issued under the sole responsibility of the product manufacturer.
4. The object of the declaration described above is in conformity with the relevant UK
Statutory Instruments:
2008 No 1597
The supply of Machinery (Safety) Regulations 2008 (and
their amendments) and the Essential Health and Safety and
the Essential Health and Safety Requirements
5. We hereby declare that the product described above, to which this declaration of
conformity refers to, we have referenced the below designated standards used in relation to
which conformity is declared:
Reference & Date
Title
EN ISO 12100 : 2010
Safety of Machinery
EN 13525 : 2020
Forestry Machinery –Wood Chippers - Safety
6. Additional Information:
The technical documentation for the machinery is available from:
Name: Matthew Cryans
Address: Unit 1C Upper Mantle Close, Chesterfield S45 9ED
Signed for & on behalf of: Crytec Limited
Place of issue: United Kingdom
Date of Issue: 24/08/2022
Name: Matthew Cryans
Function: Director
Signature:
DGS1500

SPECIFIIONS
Item Number I
Engine      
     
Displacement      
New Power     
Chipping Capacity  
Weight  
Length 
Width  
Height 
Operating RPM
Type of Fuel
Starting Method
Wheel Tire
Cutting Method
Diameter
Blade Nos.
Packaging
Package Size
Gross Weight
Cutter Disk





 


 

  
  

12cm
WARNING : EMERGENCY STOP
DANGER
WARNING
WARNING
BATTERY CONNECTION
Check belt tension before
operating chipper. Belt
deflection should be less
than 10mm when 4kg of
pressure is applied to the
belt. The belt will loosen
after the first 1-2 hours
use. You must re-check
and adjust accordingly or
the belts will begin to slip
and wear. For best
performance check for
proper belt tension every
20 hours of use.
10lb.
MAX
10mm