4 50 36 363
Saab 9-3 -M03
4Front cut:
Lay the side trim against the bracket and cut
along the length of the bracket with a knife
(120 mm).
Rear cut:
Make a cut just behind the screws.
5 Make a cut behind the front mounting towards
the floor for the cable and extract the cable from
behind the trim. Refit the side trim.
6 Connect the CD changer.
7 Insert the projecting rear part of the CD bracket
into the rear bracket, see illustration. Screw on
the front of the CD bracket.
8 Insert the CD magazine.
9 Connect the diagnostics tool, select Audio
System and the “Programming”menu. “Marry”
the CD changer to the car. This is a condition for
proper operation of the CD changer.
For operation of the CD changer, see the
Owner’s Manual.
Important
If the CD changer is to be removed from the car
and refitted in the same car, the diagnostics tool
must be connected and the CD changer
"divorced" from the car via Audio System and the
“Programming”menu.
The CD changer must be divorced while connected
to the car it was married to.
4
4
77
5
D936A604
WARNING
The CD changer is a class 1 laser product
·Service and repair of the CD changer must
only be carried out by a qualified technician.
·If the outer casing of the CD changer is
damaged, laser radiation may occur which
may cause personal injury.
