Safavieh Furniture HAC2000A User manual

NOTICE
Item ID: HAC2000A
PREPARATION Product Size: 23.6’’Wx13.8’’Dx35.4’’H
CARE AND MAINTENANCE
PIECE
Weight Capacity: 88 LBS
Warning: Do not stand on Table.
E
Leveling Feet
4X
C
Upper Pole
4X
WARNING
D
Plastic Clip
24X
A
Wire Shelf
3X
B
Lower Pole
4X
* Please make sure that you have all parts indicated and they are in good condition before you begin
assembly of this item. Refer to part list and hardware list below for guidance.
* This item should be assembled on a soft surface to prevent scratching the finish during assembly.
* This item may require periodic tightening.
* If you are having difficulty, our friendly Customer Care team is always here to help. Please email
customersupp[email protected]
* Before beginning assembly of product, make sure all parts are present. Compare parts with part
contents list and hardware contents list.
* If any part is missing or damaged, do not attempt to assemble the product.
* Estimated Assembly Time: 10 minutes.
* Tools Required for Assembly (included): No.
*Never use abrasive or acid-based cleaners on the shelf rack.
*Clean shelves and rods with a solution of mild detergent and water. Use a soft cloth or sponge to
wipe parts. Rinse and dry thoroughly.
*Keep surfaces dry and clean for a longer lasting finish.
Part List and Hardware List
DESCRIPTION
PICTURE
QUANTITY

PREPARATION
STEP 4: SCREW UPPER POLES(C) INTO LOWER
POLES BY SCREW CONNECTORS ASSEMBLED ON
UPPER POLES.
STEP 5: REFER TO STEP 1&2 TO ASSEMBLE THE
REMAINING WIRE SHELF PICTURED ABOVE.
STEP 6: PUSHING FIRMLY DOWN ON EACH SHELF
AT ITS CORNER OVER PLASTIC CLIPS AND SCREW
LEVELING FEET TO ATTAIN PROPER LEVELING.
STEP 1: SCREW LEVELING FEET(E) INTO BOTTOM
OF EACH LOWER POLE(B). SNAP PLASTIC CLIPS(D)
ONTO SAME GROOVES OF THE POLES.
STEP 2: HOLD WIRE SHELF(A) ON ITS SIDE AND
SLIDE IT FROM THE TOP OF EACH LOWER POLE
DOWN ONTO THE PLASTIC CLIPS.
STEP 3: REFER TO STEP 1&2 TO SNAP PLASTIC
CLIPS ONTO SAME GROOVES OF LOWER POLES TO
ASSEMBLE THE SECOND WIRE SHELF.
* Before beginning assembly of product, make sure all parts are present. Compare parts with part contents list and hardware contents list.
* If any part is missing or damaged, do not attempt to assemble the product.
* Estimated Assembly Time: 10 minutes.
* Tools Required for Assembly (included): No.
* If you are having difficulty, our friendly Customer Care team is always here to help. Please email customersupp[email protected]