Salini SRC-8535B User manual

OVEN BUILT IN
Instruction Manual
SOB-5002H
RANGEHOOD
Instruction Manual
SRC-3332S | SRC3335S
RANGEHOOD
Instruction Manual
SRC-3335S
RECTRACTABLE RANGEHOOD
Instruction Manual
SRR-6222W
RANGEHOOD
Instruction Manual
SRC-9535S

-1-
TABLE OF CONTENTS
Important safety information
2-3
Installation
4-5
Using your appliance
6-7
Cleaning and maintenance
8
Troubleshooting
9
Technical data
10
Declaration of conformity
11
IMPORTANT:
This User Instruction Manual contains important information, including safety &
installation points, which will enable you to get the most out of your appliance. Please
keep it in a safe place so that it is easily available for future reference; for you or any
person not familiar with the operation of the appliance.

-2-
IMPORTANT SAFETY INFORMATION
General Information
 Carefully read the following important information regarding installation safety and
maintenance. Keep this information booklet accessible for further consultations.
 This appliance is designed for domestic household use and designed be used indoors
only.
 IMPORTANT: Your product warranty will be void if the installation is not in accordance
with the instructions. The installation must be carried out by a suitably qualified person,
in accordance with the with the manufacturer’s instructions, and must be connected in
accordance with all local electrical rules specification.
 The use of this appliance for any other purpose or in any other environment will void
warranty.
 Your new appliance is guaranteed against electrical or mechanical defects, subject to
certain exclusions, the foregoing does not affect your statutory rights.
 Repairs may only be carried out by Service Engineers or an authorised service agent.
 Check the appliance for damage after unpacking it. Do not connect or install the
appliance if it has been damaged in transport as this will void the warranty.
Warning and safety instructions
CAUTION:
Ensure there is adequate ventilation of the room when the cooker hood is used at
the same time as appliances burning gas or other fuels. (Not applicable to
appliances that only discharge the air back into the room.)
 The range hood is used on 220/240v, 50Hz.
 This appliance complies with all current Australian and European safety legislation, and
designed to operate safely in normal use.
 Follow the local laws applicable for external air evacuation.
 Appliance shall only be used with rated voltage and frequency.
 There is a fire risk if cleaning is not carried out in accordance with the instructions.
 Ensure adequate ventilation in the environment for the safe operation of the range hood.
 This appliance is not intended for use by persons (including children) with reduced
physical, sensory or mental capabilities, or lack of experience and knowledge, unless
they have been given supervision or instruction concerning use of the appliance by a
person responsible for their safety.
 Please keep the room draughty when your cooker hood and gas hob are working.
 Do not exhaust the gas from cooker hood through the same heated flue which is for the
gas from gas hob and other kitchen appliances.
 Before installation and usage, read all the instructions and make sure that the voltage
(V) and the frequency (Hz) indicated on your cooker hood are exactly the same as the
voltage (V) and the frequency (Hz) in your home.

-3-
 Do not check the status of the filters while the cooker hood is operating.
 The range hood and its filter mesh should be cleaned regularly in order to keep in good
working order.
 Do not touch the light bulbs after appliance use.
 Do not disconnect the appliance with wet hands or force the supply cord.
 Disconnect the electrical plug prior to any maintenance or cleaning.
 Cleaning should be carried out in accordance with the “Cleaning and Maintenance”
section to avoid possible hazards.
 If the power cord is damaged it must be replaced by the manufacturer or a qualified
service engineer.
 In the event of any incident caused by a technical fault, disconnect the power and report
the fault to the service centre to be repaired.
 Do not dispose of electrical appliances as unsorted municipal
waste, use separate collection facilities. Contact your local
government for information regarding collection systems
available.
Electrical Caution
CAUTION! Cleaning operations must only be carried out when the range
hood is cool and disconnected from the power supply.
 Any work on electric equipment and systems may only be carried out by authorized
qualified persons.
 In case of any damage, switch off the appliance and disconnect it from the power supply
 If the supply cord is damaged, it must be replaced by the manufacturer, its service agent
or similarly qualified persons in order to avoid a hazard.
 WARNING: Ensure that the appliance is switched off before replacing the light globe to
avoid the possibility of electric shock.

-4-
INSTALLATION INSTRUCTIONS
Before installation, please ensure the area is clean to avoid suction of any remaining bits
of broken wood and dust.
The range hood cannot share the same air ventilation tube with other appliances such as
gas tubes, warmer tubes, and hot wind tubes.
The bending of the ventilation tube should be≥120°, parallel or above the start point and
should be connected to the external wall.
After installation, make sure that the extractor is level to avoid grease collection at one
end.

-5-
 The range hood should be placed at a
distance of 65-75cm (26-30inch) from
the cooking surface for the best effect.
See Pic 1.
 Install the hooks on the wall according to
the installation height and keep it level.
The fixed position of the inside chimney
bracket is the place of chimney. See Pic 2
 Fix the outside chimney bracket on the
outside chimney, and be sure that the
inside chimney height can be adjusted
freely. Attach the extendable pipe. Install
the extendable pipe and chimney on the
range hood canopy. See Pic 3.
 Put the range hood on the hook. See Pic 4.
 Adjust the height of the inside chimney to the position of the inside chimney bracket
on the wall. Once adjusted to the correct position, fix the body with the safety screws.
See Pic 5.
Note: The two safety vents are positioned on the back casing, with a diameter of 6mm.

-6-
USING YOUR APPLIANCE
Features
 The range hood uses high quality materials in a streamlined design.
 Equipped with a powerful electric motor and centrifugal leaf; it produces strong suction,
low noise and an easy to clean non-stick grease filter.
 The low voltage circuit board control is isolated (12vAC input) for additional safety.
 The special wind tunnel construction and oil collector design ensure loose dirt will be
absorbed in a second.
Touch Control with LED Display
LED Touch control have four buttons: (Timer), (Lamp), (Speed) (Power).
See Pic
 Power on: After you have connected the cooker hood to the main supply, the button
backlight will turn on. The backlight will turn off after 30s without any operation and the
cooker hood will enter into stand-by mode.
 Press button once, lights will be on. Press button again; lights will be off.
 Turn on hood and select the speed, use button “ ”, the motor works at 3 speeds, low,
mid and high, and the LED display will display “1”, “2”, “3”.
 Press once, the motor starts to work at low speed and the LED display will display
“1”,
 Press again base on the low speed, the motor works at mid speed and the LED
display will display “2”,
 Press again base on the mid speed, the motor works at high speed and the LED
display will display “3”.
 Go on pressing button, the hood works at low speed again and it repeat:
“low→mid→high→low→mid…”

-7-
 Press button once, the hood will work at the speed which it works last time. Press
button again, the hood stop working.
 The time button works when the motor is working only.
 Press , the cooker hood enter into timer setting mode. The max delay time is 9 min,
and the LED display will display “9”. When the timer is set, the LED display will display
“9”,”8”,”7”…….decreasing by every minute, when it display “0”, the motor will start
working.
Press once, the cooker hood will enter into timer setting mode, press once again,
the cooker hood will exit the timer setting mode. Press once when the cooker hood is
working at timer setting, the cooker hood will exit the timer setting mode automatically.

-8-
CLEANING AND MAINTENANCE
Cleaning Of Carbon Grease Filter Mesh
The filter mesh is made of high-density stainless steel. Please do not use a corrosive detergent
on it. Keeping this filter clean will keep the appliance running correctly. Follow the guidelines
below.
Method 1: Put the mesh into 40-50°C clean water, pour on detergent, and soak for 2-3 mins.
Wear gloves and clean with a soft brush. Do not apply too much pressure as the mesh is
delicate and will damage easily.
Method 2: If instructed to do so, it can be put into a dishwasher. Set the temperature to around
60°C.
Cleaning Range Hood
 To protect the main body from corrosion over a long period of time, the range hood
should be cleaned with hot water and a non-corrosive detergent every two months.
 Do not use an abrasive detergent for it will damage the body.
 Keep the motor and other spare parts free from water, as this will cause damage to the
appliance.
 Before cleaning the appliance please remember to disconnect from power.
 The carbon filter shouldn’t be exposed to heat.
 Do not tear open the fixed bar around the carbon filter

-9-
TROUBLESHOOTING
If you suspect that your appliance is not functioning correctly, we advise you read below
troubleshooting information to help you identify and asses how to best rectify any issues.
Servicing of the appliance must only be carried out by an authorised service representative and
the appliance must not be modified. Power must be disconnected before any servicing or
maintenance is conducted.
Fault
Cause
Solution
Light on, but motor does
not work
The leaf is blocked
The capacitor is damaged
The motor jammed, bearings
damaged
There is a bad smell from the motor
Remove the blockage
Replace capacitor
Replace motor
Replace motor
Light does not work, motor
does not work
Beside the above mentioned, check the following:
Light damaged
Power cord loose
Replace lights
Connect the wires as per the
electrical diagram
Hood Vibrates
The leaf damaged and causes
shaking
The motor is not tightly secured
The body is not tightly secured
Replace the leaf
Lock the motor tightly
Attach the body tightly
Insufficient suction
The distance between the body
and the gas top too long
Readjust the distance
The machine inclines
The fixing screws not tight
enough
The hanging screws not tight
enough
Tighten the hanging screw
and make it horizontal
Tighten the hanging screw
and make it horizontal

-10-
TECHNICAL DATA
Specifications
Model
SRC-8535B
Width
900mm
Depth
500mm
Height/Max Height
550-1030mm
Extraction/ Max Air Flow
700m3/h
Functions/Speed
3
Noise When Working
60 dB(A)
Rated Voltage
220-240V
Max Rated Inputs (Total power)
194W

-11-
DECLARATION OF CONFORMITY
Australian Standards
This product has been designed and manufactured to comply with all relevant Australian and
New Zealand Standards.
AS/NZS 60335.1 General Requirements for Domestic Electrical Appliances
AS/NZS 60335.2.6 Specific Requirements for Domestic Electrical Cooking Appliances
This appliance is SAA certified
Installation of the appliance must be only be undertaken by a licenced electrician who can
provide a compliance certificate.
This appliance is intended for domestic use only.