Samsara ACC-SC-MNT-A1 User manual

ACC-SC-MNT-A
Camera Arm Mount
Installation Guide
For more information please visit the Connected Sites Knowledge Base
at samsara.com/support.

Instructions:
*Note: the ACC-SC-MNT-A Arm Mount is only compatible with the SC Dome Camera.
1. Route the ethernet and other cables through the wall, the bracket, and the arm mount.
2. Once the cables are run through, locate the position on the wall where you want to install
the arm mount and the camera. Drill holes into the wall to secure the bracket to the wall and
fasten the screws. The holes should be 10mm in diameter and 60mm deep.
3. Atach the mounting adapter to the arm mount by rotating it clockwise until tightly fastened.
4. Use a hex wrench to secure the mounting adapter to the arm mount.
5. Connect the cabling to the dome camera, atach to the mounting adapter, and rescure the
dome camera lid.
Cables
Mounting
adapter
Dome
camera
1
2
3 4
5
Arm
Mount
Bracket