8_ setting up your new washing machine
1. Select a location for placing the washing machine.
Maintain at least 10cm between the washer and the wall if it is
placed near wall.
2. Adjust the legs on feet for levelling.
3. Method to adjust level of the washer:
Press both sides of the washer along diagonal direction to check
if it shakes. If so, adjust the leveling feet at its lower front to keep it
level.
1. Remove the adaptor from
the water supply hose.
5. Connect the other end of
the water supply hose to
the inlet water valve at the
back of the washer. Screw
the hose clockwise all the
way in.
2. First, using a “+” type
screw driver,loosen
the four screws on the
adaptor. Next, take the
adaptorandturnpart(b)
following the arrow for gap
about 5mm between them.
5-1. Connect the other end
of the water supply
hose to the inlet water
valve at the top of the
washer. Screw the hose
clockwise all the way in.
3. Connect adaptor to the
water tap by tightening the
screws firmly. Then, turn
part(b)followingthearrow
andput(a)and(b)together. a
b
If the water tap is a screw
type, assemble a water supply
hose that fits to the tap as
shown.
4. Connect the water supply
hose to the adaptor. Pull
downthepart(c)ofthe
water supply hose. When
thepart(c)isreleased,
the hose is automatically
connected to the adaptor
making a ‘click’ sound.
c
After completing connection, if water
leaks from the hose,then repeat the
same steps.
Use the most conventional type of
faucet for water supply
In case the faucet is square or too
big, remove the spacing ring before
inserting the faucet into the adaptor.