Sanyo PJ-Net Organizer Plus POA-LN02 User manual

POA-LN02
LD-Net Organizer
Network Capture 3
Network Viewer 3
Network Communication
OWNER'S MANUAL

2
Compliance
Federal Communication Commission Notice
This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to
part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interfer-
ence in a residential installation. This equipment gener-
ates, uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur
in a particular installation. If this equipment causes harmful interference to radio or televi-
sion reception which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Use of shielded cable is required to comply with class B limits in Subpart B of Part 15 of
FCC Rules.
Do not make any changes or modifications to the equipment unless otherwise specified in
the instructions. If such changes or modifications should be made, you could be required
to stop operation of the equipment.
Model Numbers : POA-LN02
Trade Name : Sanyo
Responsible party : SANYO FISHER COMPANY
Address : 21605 Plummer Street, Chatsworth, California 91311
Telephone No. : [phone]
Tested To Comply
With FCC Standards
FOR HOME OR OFFICE USE
SANYO POA-LN02

3
LD-NET ORGANIZER
OWNER'S MANUAL
Compliance and Caution
CAUTION
SANYO Electric Co., Ltd. assumes no responsibility for the loss or damage of data or
damage of the computer caused by using this product.
CAUTION ON USE IN NETWORK
- When you receive an alert e-mail from the monitor, you must check the monitor
immediately. Fire or accident may result if the monitor is used in an abnormal condition.
- When you install the monitor at remote location and use it through the network, you
must perform the safety inspections periodically. In this case you must pay attention to
the change of environment in which you installed the monitor. It may cause fire or an
accident depending on the change of environment.
The CE Mark is a Directive conformity mark of the European Community (EC).
NOTES ON Lithium Battery (CALIFORNIA USA ONLY)
This product uses a Lithium Battery which contains Perchlorate Material - special han-
dling may apply. See www.dtsc.ca.gov/hazardouswaste/perchlorate
Notas acerca de pilas de litio (SOLO PARA CALIFORNIA, EE.UU.)
Este producto usa una pila de litio que contiene el material perclorato – puede ser nece-
sario una manipulación especial.
Consulte la página www.dtsc.ca.gov/hazardouswaste/perchlorate

4
Compliance ..........................................................................................................................................................................2
Federal Communication Commission Notice ......................................................................................2
Chapter 1 Preparation ................................................................................................7
Features...................................................................................................................................................................................8
Operating environment of LD-Net Organizer............................................................................................. 11
Before use........................................................................................................................................................................... 12
Chapter 2 Installation...............................................................................................15
Flow of installation........................................................................................................................................................ 16
[1] Name and function of each part .................................................................................................................. 17
[2] Installation and network configuration.................................................................................................... 18
Mounting .................................................................................................................................................................. 18
Connection of LAN cable ...............................................................................................................................20
Network configuration.....................................................................................................................................21
Network PIN code setting..............................................................................................................................25
Notice about system construction...........................................................................................................25
[3] Installing the software.........................................................................................................................................26
Network Viewer & Capture 3 installation..............................................................................................26
File Converter 2 Installation...........................................................................................................................28
Chapter 3 Basic Setting and Operation............................................................. 29
Login the setting page of the monitor............................................................................................................30
1 Enter the IP address........................................................................................................................................30
2 Select a display mode and login............................................................................................................30
3 Display of main setting page ...................................................................................................................31
How to use the setting page .................................................................................................................................32
Initial setting.....................................................................................................................................................................34
Network PIN code setting..............................................................................................................................35
Date and time setting.......................................................................................................................................36
Network configuration...............................................................................................................................................37
E-mail setting ...................................................................................................................................................................38
Examples: Type and contents of alert mail..........................................................................................40
SNMP setting....................................................................................................................................................................42
Chapter 4 Controlling the Monitor ..................................................................... 45
Power control and status check...........................................................................................................................46
Controls................................................................................................................................................................................48
Input.............................................................................................................................................................................48
Picture adjustment ............................................................................................................................................49
Sound .........................................................................................................................................................................50
PC adjustment.................................................................................................................................................................51
Setting up the monitor..............................................................................................................................................52
Timer setting ....................................................................................................................................................................55
How to set the timer..........................................................................................................................................55
Check the timer events....................................................................................................................................56
Change the event mode.................................................................................................................................56
Monitor information....................................................................................................................................................58
Contents

5
LD-NET ORGANIZER
OWNER'S MANUAL
Contents
Multi-control.....................................................................................................................................................................59
Controlling and setting the multi-monitors.......................................................................................59
Start/stop the multi control...........................................................................................................................60
Register the monitor.......................................................................................................................................... 61
Confirmation of registered monitor......................................................................................................... 61
Change the mode of the registered monitor....................................................................................62
Status ...........................................................................................................................................................................62
Check & Change page in the light mode.............................................................................................63
Controlling all together....................................................................................................................................63
Setting all together.............................................................................................................................................63
Viewer auto setting all together.................................................................................................................64
Chapter 5 Network Capture................................................................................... 65
About Network Capture function.......................................................................................................................66
Launching the Network Capture 3...........................................................................................................66
Commands on the task bar...........................................................................................................................66
Parameter set up ..................................................................................................................................................67
Using the Real Time Capture..................................................................................................................................68
Registering the computers............................................................................................................................68
[1] Control by the computer..........................................................................................................................69
[2] Control by the web browser..................................................................................................................70
Using the Network Communication.................................................................................................................71
Settings before using the Network Communication ...................................................................72
Description of capture editing window................................................................................................73
How to use the Network Communication....................................................................................................75
Start the communication................................................................................................................................75
Join the communication (only for Sub PC).................................................................................. 75
Exit from the communication (only for Sub PC) ....................................................................... 75
End the communication .................................................................................................................................75
Acquire and release of editing authority..............................................................................................75
Edit capture image..............................................................................................................................................76
Network Communication operation and change of state .................................................................78
Executing the forcing mode ..................................................................................................................................79
Error information............................................................................................................................................................80
Chapter 6 Network Viewer ..................................................................................... 81
Creating the available data [Network Viewer 3].........................................................................................82
[1] How to use the Network Viewer 3 (File Converter 1) .............................................................82
[2] How to use the Network Viewer 3 (File Converter 2).............................................................86
Creating a program file [Program Editor].......................................................................................................87
Procedure of making program....................................................................................................................87
Setting up the display order and time of the images...................................................................89
Using the Network Viewer function..................................................................................................................92
Control by the web browser.........................................................................................................................92
Chapter 7 Appendix ................................................................................................97
Examples of connection...........................................................................................................................................98
Web browser setting................................................................................................................................................100
Examples: OS/Browsers ...........................................................................................................................................101
Product specification............................................................................................................................................... 105
Port specification........................................................................................................................................................ 106
Q&A ......................................................................................................................................................................................107

6

LD-NET ORGANIZER
OWNER'S MANUAL
LD-NET ORGANIZER
OWNER'S MANUAL
7
1
Chapter 1
Preparation
Describes features and operating environment of this product.

8
Chapter 1 Preparation
Real Time Capture function ( p.68)
To display the screen image of
the computer by the monitor
through the network in real
time.
Features
Network Viewer function ( p.81)
To acquire the JPEG image data
from the file servers placed in
the network and display them
by the monitor.
PC4PC3 PC6
Capture
PC5
PC1 PC2
PC4PC3 PC6
PC5
PC1 PC2
FTP file server
JPEG
Prog.
JPEG
MONITOR 2 MONITOR 1
Network Communication function ( p.71)
To communicate by sharing the
captured image of a computer
with multiple computers and
a monitor. User can draw the
text and figure on the captured
image by using a drawing tool.
PC2
PC6
Capture
PC5
PC1
MONITOR 1
Capture a screen
image of PC5 and
make marking with a
tool.

9
LD-NET ORGANIZER
OWNER'S MANUAL
E-mail Alert function ( p.38)
The monitor (Network Unit)
sends messages to the regis-
tered e-mail addresses when a
internal temperature abnormal-
ity or power failure occurs with
the monitor.
PC4PC3 PC6
PC5
PC1 PC2
You’ve got
Mail.
MONITOR 2 MONITOR 1
Web Management function ( p.45)
With this function, you can
check monitor functions such
as power status, input mode,
signal condition, etc. through
the network by using the web
browser installed on your com-
puter.
PC4PC3 PC6
PC5
PC1 PC2
Turn ON
MONITOR 2
MONITOR 2 MONITOR 1
Features

10
Chapter 1 Preparation
Multi-control function ( p.59)
A single computer can con-
trol and set up the multiple
monitors at the same time.
PC6
PC4
PC5
Select Input2 for
MONITOR 1 to
MONITOR4.
MONITOR 1 MONITOR 2 MONITOR 3 MONITOR 4
Automatic On/Off using Clock function ( p.55)
Automatically turn on or off the
monitors at specified date/day
and time by using the clock func-
tion.
Now it’s 11:30
I am ready to turn ON,
and select Input 3 (Video)
SNMP Manager function (refer to the separated booklet)
A func tion to manage the
condition of monitors in the
network by using the SNMP
protocol. The managing com-
puter needs to provide an
SNMP managing software. Refer
to the owner's manual of the
"PJ Network Manager" supplied
separately for further details.
PC6
PC4PC5
You received
a Trap.
SNMP Manager
Trap
Trap
MONITOR 3MONITOR 1 MONITOR 2 MONITOR 4
SNMP Agent function ( p.42)
To send the information of the
monitor to the SNMP manager.
Enables you to manage the
monitor condition with the sup-
plied SNMP manager software.
PC6
PC4PC5
You received
a Trap.
SNMP Manager
Trap
Trap
MONITOR 3MONITOR 1 MONITOR 2 MONITOR 4