3. Setup Guide
① Slide the cover in the direction of the arrow.
② Install an AAA battery and close the cover.
③ Connect the supplied lavalier microphone and/or another 3.5mm microphone to the Mic 1
and/or Mic 2 input.
④ Connect the LavMic to a camera or a smartphone by the supplied corresponding cable.
⑤ Turn the power switch to ON.
⑥ Set Mono/Stereo Switch: Select mono or stereo output mode.
The mono mode is for one mono microphone recording. It can send the mono audio signal to
each channel and mix together to output stereo audio signal.
The stereo mode is for two channels recording, it provides two separate channels of audio.
⑦ Clip the LM-M1 lavalier microphone to your shirt near the collarband.
⑧ Plug a headphone into the headphone input to monitor the audio. Please make sure that both
channels can be heard and adjust the volume control wheel if any distortion.
⑨ We suggest you could do a test recording and playback the audio to see if it is acceptable.
NOTE: Different lavalier microphone with different voltage may cause different sound
quality.
4. Specification
Inputs
1 x mic 1 1/8" (3.5 mm) jack for mono mics
1 x mic 2 1/8" (3.5 mm) jack for mono mics
Output 1 x 1/8" (3.5 mm) output
Frequency Response 20Hz to 20kHz, +/-0.5 dB
THD less than 0.03% @ 1kHz, -30 dBu input
SNR 73dB @ 1kHz, -30 dBu input
Inputs Gain Line
Mic 1: 20 dB
Mic 2: 20 dB
Power Requirements One AAA alkaline or lithium battery
Weight 107g (about 3.77 oz.)
Dimensions 8.3 x 2.7 x 3.5 cm
5. Compatibility
① Microphones with 3.5mm audio output:
• Self-powered microphone.
• Lavalier microphone operating on less than 3.3 vote.
② DSLR cameras or camcorders with 3.5mm mini jack input.
③ GoPro cameras: HERO3, HERO3 White Edition, and HERO3+ Silver and Black Editions,
HERO4 Silver and Black.
④ iPhone, iPad and iPod Touch.
3. Packing List
The LavMic unit
Three cables: LM-CC1, LM-GC1, LM-PC1
A lavalier microphone: LM-M1
