Schnick-Schnack-Systems DMX Player User manual

DMX PLAYER
USER MANUAL
english

www.schnickschnacksystems.com
1.0
2.0
3.0
4.0
5.0
6.0
7.0
Content
Description
Basic Functions
Specifications
Status Indicators
Connectivity
Cabling Examples
EU Declaration of Conformity

The player is against it the inexpensive solution
for small systems to the rendition of our streamfiles
(*.s3s). The files are stored on SD map and
inserted into the equipment. Applications are e.g.
with displays in chains of stores again. With the
player became from cost reasons consciously on
expensive elements such as displays and DMX
entrance does without.
Only a tracer to the call of the next file is present.
For the same purpose also an external tracer can be
attached.
The connection of the LED effected directly with the
red system plugs makes the wiring simple and very
economical.
1.0 Description
An SD card, carrying pre-programmed sequences, is
inserted into the appropriate slot on the DMX Player.
A single button (marked “Next”) is pressed to switch
between the programmed sequences.
2.0 Basic Functions
Dimensions:
Input Voltage:
Output current:
3.0 Specifications
151x69x45 mm
24 V DC
max. 3 A

Power LED Status Card Error Message
During software update
on off off Update in progress
on on off Error during initialisation or update
on flashes at 2,5 Hz off No firmware found – new update required
Power LED Status Card Error Message
In normal service
flashes at
0,5 Hz
off off No SD Card found on power up
flashes at
2,5 Hz
off off SD Card found
flashes at 5 Hz off off Loading configuration file from SD Card
on off On: 0.1 sec./Off: 1.9 sec. Initialising SD Card
on off On: 1.8 sec./Off: 0.2 sec. SD Card removed – player still running
on off flashes at 1,7 Hz SD Card not available
4.0 Status indication

4.0 Connectivity
The following features are located on the front of the DMX Player:
Power
The following connections are located on the rear of the DMX Player:
Data
Power
Out
IN
2
IN
1
Power
IN
Status
Reset
Next Card
Error
USB

Power:
Status:
Reset:
Next:
SD:
Card Error:
USB:
Power IN:
IN 1:
IN 2:
Data Power Out:
Illuminated green when power is connected
See tables
Press to reset the DMX Player
Press to start next sequence
SD Card slot
See tables (Status indication)
For future use
Power input connector
Connection point for external Next button
direct connection point for external Reset button
direct connection for LED components or DMX OUT
with adaptor cable on DMX 5 pin as player

5.0 Cabling examples
70 Watt Supply DMX Player
No. 1
LED Tile
C50
No. 1
LED Tile
C50
LED Tile
B50
LED Tile
B50
No. 9 No. 9
or
70 Watt Supply DMX Player
No. 1 No. 2 No. 20
Big Intelli
RGB

70 Watt Supply DMX Player
No. 1
LED Tile
C50
No. 1
LED Tile
C50
LED Tile
B50
LED Tile
B50
No. 9 No. 9
or
70 Watt Supply DMX Player
No. 1 No. 2 No. 20
Big Intelli
RGB

6.0 EU Declaration of Conformity