SCORPION ERS 4 User manual

ERS 4 POINT PHONE/TABLET INSTALLATION
INSTRUCTIONS
Tel: [phone]
scorpionsp.com
[email protected]
2. Insert the blue key into the axle of the Scorpion
(green dot side) and rotate counter-clockwise to
expand the legs wide enough for the device to fit into
the Scorpion.
1. Use supplied blue key to loosen the top and bottom
legs. Insert the key and rotate counter-clockwise to
loosen. Once loose, slide them all the way out.
3.Remove the 3M adhesive covering.
4. Place the device into the Scorpion and ensure that
the leveling plate is aligned in the center of the
device.
5. Press firmly on the front of the device to ensure the
dual lock and leveling plate fully adheres to the device.
6. Tighten the side legs of the Scorpion until they
slightly touch the side of the device by inserting the
blue key into the axle (green stickers side) and
rotating clockwise.
7. Raise the leveling plate by inserting the blue key into
the leveling plate studs. Switch back and forth between
the studs to ensure equal pressure.
NOTE: Do not over tighten NOTE:3 turns and switch until plate is raised
Before installing, use supplied blue key to unlock
Scorpion axle. Unlock by turning counter clockwise.
*IMPORTANT* PLEASE READ BEFORE INSTALLING

9. To lock axle, insert the blue key into the center of the
Scorpion body located on the back side of the device.
Turn the supplied blue key clockwise to tighten the
screw and lock the axle into place.
10. Secure top and bottom leg by inserting the blue key
into the center of the Scorpion Body located on the
back side of the device. Turn the blue key clockwise to
tighten the screw and lock the axle into place.
11. Feed charging cable through before attaching
Scorpion to the base.
12. Place the installed device into the receiver.
Press the lock in to secure. Scorpion should now be
locked into place.
8. After securing leveling plate, go back and tighten
side legs. There will no longer be a gap between the
screen and legs when the leveling plate has been
properly raised.
IMPORTANT
Do not over tighten the leveling plate.
If you see a bump or bubble in the screen,
or bend in the device, the leveling plates
are over tightened.
Please refrain from over tightening as this
may damage the device.
*IMPORTANT* MUST LOCK AXLE TO FULLY SECURE