
©Sound Control Technologies Inc., 2020 • www.soundcontrol.net • Tech Support: 203-854-5701
Complete Assembly
Shown with RCM-CP6™ Shelf
Assembled Steps 1-5
Three-Quarter View
ASSEMBLY INSTRUCTIONS
Step 1: Secure the Wall Mount Plate (No. 1) to a standard 2-Gang
Electrical Box or Trim Ring (No. 2) using the [4] black 6-32 x 3/4”
Oval Head Screws (No. 3).
Step 2: Attach the Mounting Bracket (No. 4) to the Camera-End
Module (No. 5) using the [2] 6-32 x 1/4” Pan Head Screws (No. 6).
SStep 3: Secure the Cover (No. 7) to the Step 2 assembly using [1]
8-32 Cap Nut (No. 8).
Step 4: Connect your SCTLink™ CAT5e/CAT6 cable (integrator
provided) to the Camera-End Module (No. 5).
Step 5: Hook the bottom of the Cover (No. 7) to the Step 1 assembly
and fasten using [1] 8-32 Cap Nut (No. 8).
SStep 6: Attach the Camera Shelf (No. 9) to the two studs at the
bottom of the Wall Mount Plate (No. 1) using [2] 8-32 Cap Nuts
(No. 8). Please Note: Flange side must face down for support.
Step 7: Secure your camera to the Camera Shelf (No. 9) using the
provided Thumb Screw(s); Please see reverse for style/quantity
depending on your camera shelf model (No. 10).
Break-out tab for
wire pass-through
if required.
9
THIS
SIDE UP
8
8
8
7
6
5
4
3
2
1
BEFORE YOU GET STARTED:
Please make sure that you have all parts indicated before you begin mount assembly,
and that any in-wall boxes or trim rings are mounted in accordance with commercial construction best practices.
Please Note: Steps 1-5 (illustrated below) are universal for our entire series of RCM™ mounts. The RCM™ mount
becomes camera specific in Steps 6-7 with the camera shelf chosen to match the base of your camera.
RCM Series™ Camera Mount Installation Instructions