SeaHawk LD-ENC User manual

LD-ENC Quick Start Guide
hank you for purchasing the SeaHawk LD-ENC enclosure for the
SeaHawk LD1500 and LD2000 leak detection controllers. This guide
describes how to install the LD-ENC
If you need further assistance, contact RLE Technologies on our
website at http://www.rletech.com/ (go to the Support Link) or by
calling 970.484.6510, Option 2.
1Supplies for Installation
Included with the LD-ENC
LD-ENC unit
Sold Separately
Circuit breaker
SeaHawk LD1500 or LD2000 leak detection controller
SeaHawk Leak Detection Cable (sensing cable)
2Installing the LD-ENC
Mount the enclosure by performing these steps (refer to the illustration on the
next page):
1 Remove the back plate from the enclosure by removing the four
mounting screws.
a If conduit will run to the enclosure, remove the knock outs from the top
or bottom of the enclosure.
b Mount the enclosure in the desired location.
2 If not already done, mount the LD1500 or LD2000 onto the back plate
and connect the output power cables from the enclosure’s power supply
to the leak detection device.
3 Replace the back plate in the enclosure.
4 Run the necessary wiring through the enclosure.
5 Ensure proper input power is connected to the enclosure’s power supply.
6 Turn the unit on by positioning the green power switch in the On position
T

©2010 RLE Technologies. All rights reserved. RLE is a registered trademark, and
SeaHawk, Falcon, and Raptor are trademarks of RLE Technologies. All other
trademarks or registered trademarks are the property of their respective companies.
Although the information contained in this document is believed to be accurate and
correct, RLE Technologies assumes no responsibility, and disclaims all liability, for
any damages resulting from the use of this information or any error or omission in this
document. RLE Technologies does not warrant, guarantee, or make any
representations as to the performance, fitness for use, safety, or reliability of any
existing or future wiring, equipment, additions or modifications to equipment, or any
other component of the original or modified system. Specifications are subject to
change without notice. Part number 110083 Rev. 1.0 6/2010
104 Racquette Drive
Fort Collins, CO 80524
970.484.6510
www.rletech.com
IMPORTANT RLE strongly recommends that low-voltage and high-voltage wiring
are not placed in the same conduit. Electrical interference could result.
Conduit Knockouts
24VDC Output with Cables
Power (On/Off) Switch
AC Power Input Terminal
Block
Conduit Knockouts
WARNING
A dedicated circuit breaker must be provided within
close proximity to the enclosure and be clearly marked
as the disconnecting device for the unit inside the
enclosure.