ServAPure Millipore WMBSMT001 Reference guide

WALL MOUNTING BRACKET 1
Cat. # WMBSMT001
Installation Procedure
Where used SMART Direct Q - SMART RiOs Di - SMART RiOs
Introduction This insert explains how to install the Wall Mounting Bracket 1 (with Ball Valve).
• Wall Bracket with Fittings,
• Ball Valve,
• 8 mm Tubing,
• 4 screws.
Hardware to secure the bracket to the wall.
Attention!
Verify that the wall can support the weight of the system when filled with
water. The operating weight can be found in the manual coming with the
system.
Attention)
The screws needed to secure the bracket to the wall are not included and must
be purchased separately. Make sure to use the appropriate screws for the wall
surface.
The information in this document is meant to be used by a Qualified Service Representative
P F 0 9 5 1 9 - R e v . 2 , 0 5 / 2 0 1 4 w a l l m o u n t i n g B r a c k e t i 1 / 2

Procedure Step Action Illustration
Using the Wall Mounting Bracket, trace the
wall mounting holes onto the wall. This will
give you an accurate location for drilling the
holes.
120
''
/////////////
Drill the 4 holes and bolt the bracket to the wall using the appropriate screws
for the type of wall.
Connect the ball valve to the fitting at the
bottom of the Wall Mounting Bracket.
fr\M
Use the length of tubing provided to connect
the elbow fitting on the top of the bracket to
the tank outlet of the system.
Place the system on the Wall Mounting Bracket being careful not to let the
system fall off. Align the holes on the bottom of the system to the holes on the
bracket.
While holding onto the system, tighten the screws from the bottom of the
bracket into the bottom of the system. Make sure the system is securely
fastened to the bracket.
T h e i n f o r m a t i o n i n t h i s d o c u m e n t i s m e a n t t o b e u s e d b y a Q u a l i fi e d S e r v i c e R e p r e s e n t a t i v e
P F 0 9 5 1 9 - R e v . 2 , 0 5 / 2 0 1 4 w a l l m o u n t i n g B r a c k e t i 2 / 2