Seville Classics OFF65864 AIRLIFT 25 User manual

Customer Service Informaon
Telephone: [phone]
Fax: [phone]
Hours: 8:30 AM – 4:30 PM (PST)
Email: Suppor[email protected]
Homepage: www.SevilleClassics.com
FAQS
Q. Can I aach a monitor stand to it? What about dual monitors?
A. Yes! But be sure the desk is below it's 22 lbs. maximum weight limit.
Q. Do I need to plug it in?
A. Nope! It's fully pneumac. Just set it on the table and get started!
052019
Specicaons
Top dimensions: 25.2" W x 17.9" L
Tray dimensions: 25.3" W x 10.6" L
Base dimensions: 15.7" W x 19.7" L
Overall dimensions: 25.2" W x 28.5" L x (4.7" to 16.5" H)
Maximum weight on tray: 5 lbs. (2 kg.)
Maximum weight overall: 22 lbs. (10 kg.)
Use Instrucons
1. Pull up on AIRLIFT® lever and desk top to li.
2. Pull up on AIRLIFT® lever and press down on desk top to lower.
AIRLIFT® 25 Personal
Standing Desk Converter Riser
Model: OFF65864
Thank you for choosing Seville Classics! We hope that you enjoy your
standing desk converter! Please read through this user guide for parts
list, assembly instrucons, frequently asked quesons and further
contact informaon.
052019

Parts List
A. Desk (1)
Please make sure you have all the parts on this list.
If you’re missing parts, contact us for replacements at
[phone] or send an email to [e-mail]
Screwdriver
Required Tools (not included)
1
B. Keyboard Tray (1)
C. Bracket (1)
D. Long Screw (4)
E. Short Screw (4)
DO NOT place devices on
desk edge.
DO NOT route wires
underneath desk.
MAKE SURE devices have
cables long enough for the full-
range (11.8 in/29.9 cm) of
height-adjustment.
DO NOT quickly li desktop
when loaded.
Failure to follow these instrucons may result in
property damage or personal injury.
Safety
6

STEP 5. Place your belongings on the desktop to nish!
WARNING: DO NOT PLACE HANDS ON
DESK LEGS. MOVING PARTS CAN CRUSH.
5
Congratulaons! Enjoy your new AIRLIFT standing desk!
Assembly Instrucons
STEP 1. Remove AIRLIFT® desk from box.
2
STEP 2. Remove strap.
Requires 2
people to li

STEP 3. Squeeze the AIRLIFT® lever to li desk.
3
STEP 4. Install BRACKET (C) with SHORT SCREWS (E) and screwdriver.
STEP 5. Align holes on base of KEYBOARD TRAY (B) to BRACKET (C)
and aach with LONG SCREWS (D) and screwdriver.
4