Shadow 390016 User manual

have many hours of enjoyable use with your new AHB Foosball Table!
PLEASE KEEP YOUR INSTRUCTIONS!
•Your Model number is necessary should you
need to contact us.
•Please read through this instruction book to
familiarize yourself with all the parts and assembly
steps.
•Refer to parts ldentifier and verify that all parts
have been included.
WARNING!
This is not a child’s toy. Adult supervision is required for children playing this game. Please read instructions
carefully. Proper use of this set can avoid damage or injury.
BEFORE ASSEMBLY:
•Did you receive 1 box?
•Did you inspect your playield/main table frame before assembly? It is not replaceable and must be returned to the
original place of purchase if damaged.
TOOLS REQUIRED FOR ASSEMBLY:
•Phillips and Slotted Head Screwdrivers / or Power Driver (not included)
•Allen Wrench (included)
ASSEMBLY INSTRUCTIONS:
We recommend that two adults work together to assemble this table.
•The table will be assembled u
p
side down This is a ver
y
heav
y
table and turnin
g
it ri
g
ht side u
p
will re
q
uire at least
two stron
g
adults.
•We su
gg
est that
y
ou use the bottom carton as a clean flat wor
k
area
Congratulations!
We hope you will

Attach Leg (#2) to the cabinet using washers (#16) and bolts (#15).
Attach Leg Levelers (#25) to all four legs.
Using two strong adults,flip the table on its legs.
Step 1:

Attach playfield trim (#17).
Step 2:

Slide one end of the Player rods through the cabinet
NOTE:The Player Rods have a hole on the end where the Rod Grips
will go in the next step.
Player Rod Assembly:
Place one Rubber Bumper (#10) on the rod.
Place one Plastic Washer (#13) on the rod.
Place the appropriate number of Players (#6 or #7) on the rod (3 Players on the
3-hole rod, 2 players on the 2-hole rod, etc.).
Attach the Players (#6 or #7) on the rod using one Bolt (#8) and one Nut(#9) per
Player.
Place one Plastic Washer (#13) on the rod.
Place one Rubber Bumper (#10) on the rod.
Slide end of the Player rods through the cabinet
Repeat for each rod.
NOTE:The players of each team should be right-side up, facing
their opponent’s goal.
Step 3:

Attach the ball Entry Cups (#21) to the outside of the Side Aprons
using Screws(#20) .
Place the Hand Grips (#12) onto each Player Rod with the holes
and attach using one bolt (#11) per Hand Grip .
Attach Rod End Caps (#14) .
NOTE: The goalie should be at your left .
Place the Scorer Assemblies (#18) onto the end rails and attach with two
Screws (#19) per Scorer.
Assembly is now Complete
Step 4: