Progress HangTime Wall Mount User manual

HangTimeTM Wall
Mount
for Skateboard Decks
(Threaded Mount)
HangTimeTM Wall Mount Package Contents
1. The product includes 1 HangTimeTM Mount Assembly for mounting a single skateboard deck; wall
bracket and threaded mount housing.
2. Screw fasteners and screw anchors for mounting to the wall.
3. Screw fasteners for assembling the upper mount housing to the wall bracket.
4. Screw fasteners for mounting your skateboard deck to the HangTimeTM Wall Mount.
5. Instructions.
HangTimeTM Wall Mount for Skateboard Decks Instructions
IMPORTANT: Determine the location for the HangTimeTM Wall Mount. Wall must be sound, strong enough to support the HangTimeTM
mount and your skateboard. Do not hang on a ceiling or angled walls unless there is sufcient support to hold the board and mount.
Location must be free from obstructions, away from beds, doors and trafc areas. It is recommended that your HangTimeTM mount
be mounted using the screws and anchors provided. HangTimeTM is not responsible for improper or inadequate mounting. Assembly
requires a Phillips screwdriver and a 3/16” drill. Use of a cordless screwdriver or drill with a Phillips bit will make installation easier.
PLEASE CONTACT US AT 860-436-4470 IF YOU REQUIRE ADDITIONAL HELP
DURING INSTALLATION.
H
a
n
g
T
i
m
e
U
S
A
.
c
o
m
HangTimeTM Wall Mount
for snowboards
Other HangTimeUSATM Products:
Magnetic Skateboard Wall Mount
for temporary skateboard mounting
Made in the USA by Progress, Inc.
HangTimeTM and HangTimeUSATM are trademarks of Progress, Inc. Newington, CT
www.HangTimeUSA.com [email protected]
Copyright 2012. Progress, Inc. All rights reserved.
Tools Required (not included)
Drill 3/16” Drill Bit
Phillips Screwdriver

Installing Your HangTimeTM Wall Mount for Skateboard Decks
1. Using the hardware supplied, attach
the wall bracket to the wall in the desired
position. Use the wall bracket as a template
mark the wall with the screw locations in
each slot. It is recommended that the
screws be in a top and bottom corners.
HangTimeTM
Mount
Skateboard Deck
10-32
Screws
Mark Wall in
Slots as shown
Mark Wall in
Slots as shown
Wall
Bracket
Long Screws
Wall Bracket
Wall
Wall Anchors
Drill a 3/16”
dia hole
STEP 2
STEP 3
STEP 1
2. Drill a 3/16” hole and insert the wall
anchors. Screw the wall bracket to the wall
using the longer screws.
Thank you for purchasing our product!
www.HangTimeUSA.com [email protected]
3. Attach the threaded housing to the wall
bracket with the 2 shorter screws supplied.
Become a Fan! Share a photo!
Attaching Your Deck to the HangTimeTM Wall Mount
4. Using 4 skateboard truck screws or
supplied 10-32 pan head screws attach your
deck to the wall mount.
5. Enjoy…
STEP 4