Shell SH912 User manual

POL BOOSTSTATUS
Red LED
Green / Red LED
Jump Start
Troubleshooting
Jumper cable signal
POL SoundStatus Cause
Off OffSolid Green
Off Off
Flashing
Green
1. Vehicle’s battery cannot be detected.
Off Off
Red & Green
light flashes
alternately
Over-voltage protection.
Over-current protection
Off Off
Red light
flashes rapidly
1. High temperature protection.
2.Voltage of the jump starter is too
low / overdischarge protection.
Jump started 4 consecutive times within
10 minutes.
Off
Solid Red
Red light
flashes slowly
Solid Red
Flashing
Green
Off
Off
Constant
Beeping
3. Jumper cable not connected
to the jump starter.
Reversed polarity protection. Battery clamps
are connected to the wrong
polarities of the vehicle battery.
Off
2. Short circuit protection.
3. Vehicle’s battery voltage is too low
or cannot be detected.

*WARNING Use “BOOST” with extreme care. Clamps must be tightly connected to the correct polarities
of the vehicle’s battery before pressing boost button. Spark proof and other safety protections will be
disabled after pressing boost button. This mode generates very high current. Sparks will generate when
clamps touch or are connected to each other. It may cause damage to the product and the vehicle’s
electrical system if not used properly. Seek professional assistance if you are not sure about using this mode.
Solutions
Jump start the vehicle.
Make sure the clamps are securely connected to the correct polarities of the vehicle’s battery.
Press “BOOST” on the jumper cable. Solid green LED light will turn on. Jump start the vehicle.
*See warning below.
Disconnect the jump starter and jumper cable from the vehicle. The vehicle’s battery voltage is
higher than applicable. This product is suitable for 12V battery only.
Disconnect the jump starter and jumper cable from the vehicle. Check and make sure the vehicle
starter is not stuck. Wait 30 seconds. Follow jump starting vehicle instructions to jump start the
vehicle.
Disconnect the clamps from the vehicle’s battery. Unplug the jumper cable from the jump
starter. Let the jump starter cool down by putting it in a cool and ventilated place.
Charge the jump starter.
Do not jump start more than 4 times. Disconnect the clamps from the vehicle’s battery.
Unplug the jumper cable from the jump starter. Consult a mechanic.
Connect jumper cable to the jump starter before connecting the clamps to the vehicle battery.
Disconnect the clamps from the vehicle’s battery. Unplug the jumper cable from
the jump starter. Follow jump starting vehicle instructions to jump start the vehicle.
Make sure the clamps are securely connected to the correct polarities of the vehicle’s battery
Make sure the clamps are securely connected to the correct polarities of the vehicle’s battery

Charging Portable Devices
1. Connect your portable device with one end of the USB
cable, and insert the other end to one of the output ports:
USB-A 1, USB-A 2 or Type-C port, of the jump starter. Note: to
use the fast charging function, please use the Type-C port.
Compatible with: smart phones, tablets, digital cameras, mobile
gaming devices, wireless earphones and more.
Note: Charging time will vary depending on the portable device
and the device’s battery capacity.
2. Charging will begin as soon as the connections are made.
3. Once the charging is completed, disconnect your portable device
and unplug the USB cable from the jump starter.

Using the Flashlight
1. To switch on the flashlight, press and hold
the ON/OFF button for 2 seconds.
2. Press the ON/OFF button once to toggle
through 4 light settings: Flashlight, SOS,
White Flood Light, and Red Alert Strobe.
This
𝌂
symbol indicates direct current (DC)
Specifications
Start Voltage 12V
Start Current 400A
Peak Current 800 A
Input Micro USB: 5V 𝌂 2A
Type-C: 5 V 𝌂 3A, 9V 𝌂 2A, 12V 𝌂 1.5 A
Output USB-A 1: 5V 𝌂 2.4A
USB-A 2: 5V 𝌂 2.4A
Type-C: 5 V 𝌂 3A, 9V 𝌂 2A, 12V 𝌂 1.5 A
Battery Type Lithium-Polymer
Battery Capacity 12000 mAh, 44.4 Wh
Operating Temperature –20ºC ~ 60ºC
Storage Temperature –20ºC ~ 40ºC
Charging Temperature 0ºC ~ 45ºC
Dimensions 6.9 ×3.5× 1.4 in / 176× 88 ×36 mm
Weight 1.16 lb/506 g (without clamp and USB cable)
3. Press and hold ON/OFF button for 2 seconds to switch off
the flashlight.

Failure to follow the instructions may cause serious injury, death or property
damage.
Risk of electric shock, explosion and fire.
Risk of explosive gases.
Do not attempt to jump start your vehicle more than four consecutive times. If
the vehicle does not start after four consecutive attempts, consult a mechanic.
The product may become warm under extended high-power operation.
Do not disassemble, modify or repair this product.
Do not destroy product by crushing or cutting.
Do not expose the product to fire, rain, snow, sunlight and heat.
Keep this product away from water and other liquids.
Keep this product in a dry place. Do not allow the product to get wet.
Use the product in a well-ventilated area. Do not operate in explosive
atmospheres such as areas of flammable gas, dust and liquid.
Do not use this product in the event of electrolytic liquid leaks, strange odours,
overheating, color change or when any other peculiar occurrence is detected.
Handle the product with care. Do not use the product when it is damaged.
Do not operate with damaged jumper cable or clamps.
Clean this product only with a dry cloth. Avoid using cleaning product with
rough or chemical substances.
Do not look directly into the light as it may cause serious eye injuries.
This car jump starter is for use with gasoline or diesel engine vehicles using a
12 V battery only. The use of this jump starter on a vehicle that does not have a
12V battery may cause serious damage to the vehicle, the jump starter, and/or
serious injury to the user. Refer to the owner’s manual of the vehicle for the
battery voltage.
The product should not be charged while in contact with flammable material
like textiles.
When charging the jump starter, use the USB cable and car charger/adapter
that are provided in the package (accessories included in the package vary
depending on the model). When using a different USB cable, charger, or
adapter, make sure it is certified according to the safety standards in your
country/region.
Use the accessories that are provided in the package. Shell is not responsible
for any damage or injury when using accessories that are not provided by us.
Connect the jump starter only with the jumper cable provided in this package.
Do not put the jump starter directly above the vehicle battery during
jump starting.
Do not jump start a vehicle while recharging the internal battery.
Do not allow the clamps to touch each other.
Keep out of reach of children.
Safety Instructions

Personal Precautions
Wear adequate eye protection and protective clothing when working near
a vehicle battery.
Do not smoke or allow a spark or flame near the battery or engine.
Remove all metal objects such as rings, bracelets, and watches.
Have plenty of fresh water and soap nearby in case of battery acid contact
with eyes, skin or clothing.
If battery acid comes in contact with the skin or clothing, immediately wash with
soap and water. If the acid enters the eye, immediately flood eye with running
cold water for at least 10 minutes and seek immediate medical attention.
Beware not to drop metal items on the battery. It might cause sparks or short
circuit the battery.
Consider having someone nearby to come to your aid in case of emergency.
Incompatible or damaged vehicle batteries may explode when used with
this product.
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference,
and (2) this device must accept any interference received, including interfer-
ence that may cause undesired operation.
Please note that changes or modifications of this product is not expressly
approved by the party responsible for compliance could void the user’s
authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television recep-
tion, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
- Consult the dealer or an experienced radio / TV technician for help.

Warranty
Shell warrants that this product (the “Product”) will be free from defects in
material and workmanship for a period of two (2) years from the date of
purchase (the “Warranty Period”). For defects reported during the Warranty
Period, Shell will, at its discretion, and subject to Shell’s product support
analysis, either repair or replace defective Product. Replacement parts and
products will be new or serviceably used, comparable in function and per-
formance to the original part and warranted for the remainder of the original
Warranty Period. SHELL’S LIABILITY HEREUNDER IS EXPRESSLY LIMITED
TO REPLACEMENT OR REPAIR OF THE PRODUCT. TO THE MAXIMUM
EXTENT PERMITTED BY LAW, SHELL SHALL NOT BE LIABLE TO ANY PUR-
CHASER OF THE PRODUCT OR ANY THIRD PARTY FOR ANY SPECIAL,
INDIRECT, CONSEQUENTIAL OR EXEMPLARY DAMAGES, INCLUDING
BUT NOT LIMITED TO, LOST PROFITS, PROPERTY DAMAGE OR PERSONAL
INJURY RELATED IN ANY WAY TO THE PRODUCT HOWSOEVER
CAUSED, EVEN IF SHELL HAD KNOWLEDGE OF THE POSSIBILITY OF
SUCH DAMAGES. THE WARRANTIES SET FORTH HEREIN ARE IN LIEU
OF ALL OTHER WARRANTIES, EXPRESS, IMPLIED, STATUTORY OR OTHER-
WISE, INCLUDING, WITHOUT LIMITATION, THE IMPLIED WARRANTIES
OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE,
AND THOSE ARISING FROM COURSE OF DEALING, USAGE OR TRADE
PRACTICE. IN THE EVENT THAT ANY APPLICABLE LAWS IMPOSE WAR-
RANTIES, CONDITIONS OR OBLIGATIONS THAT CANNOT BE EXCLUD-
ED OR MODIFIED, THIS PARAGRAPH SHALL APPLY TO THE GREATEST
EXTENT ALLOWED BY SUCH LAWS.
This Limited Warranty is made solely for the benefit of the original purchaser
of the Product from Shell or its approved reseller or distributor and is not
assignable or transferable. To make a warranty claim, the purchaser must:
(1) request and obtain a return merchandise authorization (“RMA”) number
and return location information (the “Return Location”) from Shell Support
by emailing [email protected] or by calling 1.833.990.2624 ;
and (2) send the Product, including RMA number and receipt to the
Return Location provided. DO NOT SEND IN PRODUCT WITHOUT FIRST
OBTAINING AN RMA FROM SHELL SUPPORT. THE ORIGINAL PUR-
Battery Disposal
The product contains a Li-ion/rechargeable battery which must be recycled or
disposed of separately from household waste. Dispose of batteries according to
your local environmental laws and guidelines.

CHASER IS RESPONSIBLE (AND MUST PREPAY) ALL PACKAGING AND
TRANSPORTATION COSTS TO SHIP PRODUCTS FOR WARRANTY
SERVICE. NOTWITHSTANDING THE ABOVE, THIS LIMITED WARRANTY
IS VOID AND DOES NOT APPLY TO PRODUCTS THAT: (a) were misused,
mishandled, subjected to abuse or careless handling, accident, improperly
stored, or operated under conditions of extreme voltage, temperature, shock,
or vibration beyond Shell’s recommendations for safe and effective use; (b)
improperly installed, operated or maintained; (c) are/were modified without
the express written consent of Shell; (d) have been disassembled, altered or
repaired by anyone other than Shell; (e) had defects which were reported
after the Warranty Period. THIS LIMITED WARRANTY DOES NOT COVER:
(1) normal wear and tear; (2) cosmetic damage that does not affect
functionality; or (3) Products where the Shell serial and/or lot number is
missing, altered, or defaced.
Warranty
Contact us
For any questions regarding your
warranty or product contact
Shell Support at:
[email protected]
1-833-990-2624
Monday - Friday 9 am - 5 pm
Eastern Standard Time
Camelion North America Inc.
2572 Daniel-Johnson Blvd. | 2nd Floor
Laval, QC, H7T 2R3, Canada
CAN ICES-3(B) / NMB-3(B)
CONFORMS TO ANSI/CAN/UL
STD.2743

Printed in China
SH912
Portable Power
Jump Starter
SH SH912 IM ENG D10100R5