Shure WA501 User manual

Model WA501
Instruction Sheet
©2004, Shure Incorporated
27B8403 (Rev. 3)
Printed in U.S.A.
SHURE Incorporated Web Address: http://www.shure.com
5800 W. Touhy Avenue, Niles, IL 60714-4608, U.S.A.
In U.S.A., Phone: [phone] Fax: [phone]
In Europe, Phone: [phone] Fax: [phone]
In Asia, Phone: [phone] Fax: [phone]
International Fax: [phone]
WA501 Front Mount Antenna
Rack Mount Kit Installation
1. Remove and save the screws from
each side of the SC4 receiver, as
shown.
2. Secure the supplied brackets to the
sides of the receiver with the screws
removed in Step 1.
NOTE: There are four holes in each
bracket. Use the rear holes if the receiver
is to be recessed; use the front holes to
mount receiver flush to the rack.
3. Insert the two bulkhead adapters
through the holes in the front panel,
and secure them from each side,
using the supplied attaching hard-
ware.
4. Connect the supplied antenna cables
to the receiver antenna inputs and
the bulkhead adapters, as shown.
5. Insert the receiver into the equipment
rack and secure the brackets to the
rack with the supplied screws.
6. Screw the antennas into the bulk-
head adaptors protruding through
the front panel.
SC4 RECEIVER
(TOP VIEW)
FRONT
BRACKET BRACKET
SC4 RECEIVER
(TOP VIEW)
FRONT
BULKHEAD
ADAPTER
SC4 RECEIVER
(TOP VIEW) BULKHEAD
ADAPTER
FRONT
BULKHEAD
ADAPTER
SC4 RECEIVER
(TOP VIEW) BULKHEAD
ADAPTER
FRONT
EQUIPMENT RACK
ANTENNA ANTENN
A
SC4 RECEIVER
(TOP VIEW)
FRONT