
Water softening system/Special salt en
11
To change the language:
1. Open the door.
2. Switch on ON/OFF switch (.
3. Hold down programme button #
and press START button )" until
the digital display 8•:‹... is
indicated.
4. Release both buttons.
5. Press programme button #until
the factory set value p:‹‚ is
indicated on the digital display 8.
“German” (Deutsch) is indicated in
the display window )2.
6. Press programme button 3.
Each time the button is pressed, the
set value increases by one level;
when the value of p:ƒ„ has been
reached, the display jumps back
to p:‹‚
7. Press START button )".
The set value is saved.
8. Close the door.
Display window
The display window )2 shows
the selected programme, the remaining
running time, the programme sequence
(in words and as a coloured progress
bar) and the selected options. In
addition, when there is low salt and/or
low rinse aid, the number of rinse cycles
still possible is indicated and the fault is
stated in the event of faults.
When the onboard computer
is switched on (see corresponding
chapter), further information is shown
and the water and energy consumption
is briefly displayed.
+Water softening
system/Special salt
Water softening system/Special salt
To ensure good washing results,
the dishwasher requires soft water, i.e.
containing low amounts of lime,
otherwise white limescale will be
deposited on the utensils and inner
container.
Tap water above 1.2 mmol/l must be
softened. The water is softened with
special salt (regeneration
salt) in the water softening
system of the dishwasher.
The setting and therefore the required
amount of salt
depends on the degree of hardness of
your tap water (see table).
Setting
The amount of salt dispensed can be
set from •:‹‹ to •:‹ˆ.
Salt is not required at the set value
•:‹‹.
1. Find out about the hardness value of
your tap water. Your water utility
company will help you with this.
2. Set value can be found in the water
hardness table.
3. Open the door.
4. Switch on ON/OFF switch (.
5. Hold down programme button #
and press START button )" until
•:‹.... is indicated on the digital
display.
6. Release both buttons.
The LED for button #flashes and
the digital display 8displays the
factory setting •:‹….