
USING YOUR MULTI-CHOPPER
1. Carefully remove the plastic cover from the blade.
IMPORTANT: Use caution when handling blades as they are extremely sharp.
Always hold blades by the plastic stem, not the blade itself.
2. Place the blade in the center of the chopping bowl.
3. Add food to be processed.
4. Place the cover on the chopping bowl.
5. Insert the motor housing onto the cover.
6. Plug the power cord into a 120V AC power outlet.
7. Press down on and release the motor housing top for short bursts to produce a
pulsing action. Avoid over processing the ingredients.
8. Unplug after use and then remove the motor housing and cover.
9. Carefully remove the blade.
10. Remove the processed food from the chopping bowl.
NOTE: There may be a small amount of smoke and smell during the rst use of the
appliance - this is normal.
IMPORTANT
1. Do not run the Multi Chopper continuously for longer than 30 seconds.
2. For best results always use the pulse method
3. Never operate the Multi Chopper with the bowl completely lled with liquid.
4. It is not recommended to use the chopping blades for extremely hard foods such
as coee beans, nutmeg or other hard spices.
5. Do not place this appliance in the microwave.
4
CARE AND CLEANING
• Ensure that the unit is unplugged from the electrical outlet before cleaning.
• Wipe the motor housing with a damp cloth. Dry thoroughly. Do not use any abrasive
cleaners or scouring pads on the housing as this will damage the nish.
• Wash the bowl, cover and blades (except motor housing) in warm water using a
mild detergent (or see dishwasher instructions below). IMPORTANT: Use caution
when handling blades as they are extremely sharp. Dry each part thoroughly
before use.
Dishwasher Use
All parts of your chopper are tolerant to dishwasher use, (excluding the motor
housing). If using the dishwasher, place parts only on the top rack.