Skutchi Harmony Series User manual

HARMONY
SERIES
888-993-3757
Installation Guide

Step 1:
Turn over top to be able to screw in
the base.
Next place the side of the base
with the holes on to the top and
make sure it is centered.
Screw the base to the worksurface
using screws that are provided. Stand table right side up.
Step 2:
Step 3: Step 4:
Installation
Top Base Screws
1
*General Instructions:
Actual product may vary slightly
Bottom side of
table top
Bottom side of
table top

Flat Bracket
Installation for 2 or more bases with two table tops
Step 1: Step 2:
Screws
Top Bases
Step 3:
2
*General Instructions:
Actual product may vary slightly
Turn over tops and slide
together to be able to screw
in the bases.
Bottom side of
table top
Next place one base on each table top and center it. Attach bases by
the side with the holes on to the top. Screw the bases into the top.
After the two bases are attached, place flat brackets on the connecting line of the tops at an
angle (see image below). Then screw into place.
Flat Bracket
Flat Brackets will be
needed on certain size
tables for extra support.
*Make sure flat brackets
are secure before
attaching a third base
or standing table upright.

Stand table right side up.
Step 5:
Step 4:
For large tables a third base may be needed. If so,
connect base to top at the middle of the table.
3