SkyBound CURVED POLE AND TOP RING TRAMPOLINE NET Setup guide

TRAMPOLINE NET
CURVED POLE AND TOP RING
ASSEMBLY AND INSTALLATION MANUAL
www.TrampolinePartsCenter.com
2017 - 2019 FULOO LLC - ALL RIGHTS RESERVED
-Kiki (CEO) & Team SkyBound
For customer service, please contact:
888-891-4689
Monday through Friday
8:00 am to 5:00 pm PST
or visit www.SkyBoundUSA.com
[email protected]
A PERSONAL MESSAGE FROM OUR CEO
or www.TrampolinePartsCenter.com
When I shop, I am not just buying a product or
service. I purchase why that brand focuses on
what they do, what their corporate philosophy is,
the quality of their products, and whether or not
my personal core values align with that brand’s
vision. When I don’t feel great about a company’s
brand, products, or how I’m being treated as a
customer, then I know they are not delivering on
what matters most: exceeding the customer
expectation by delivering happiness with their
products, quality, and service.
This primary focus is what drives our culture at
Team SkyBound. For supporting our vision, we
would like to personally thank you for trusting us
to deliver happiness to you and your family!
“Nurturing the inner-child in all of us by
uniting communities worldwide and
promoting an active lifestyle.”

ASSEMBLY INSTRUCTIONSASSEMBLY INSTRUCTIONS
STEP 1 STEP 3 STEP 4
SkyBound, a Fuloo, LLC Company.
SkyBound is a registered trademark of Fuloo, LLC
in the U.S. and other countries. All logos, names,
characters, likenesses, images, slogans and
packaging appearance are the property of SkyBound.
PLEASE KEEP THIS MANUAL AS IT CONTAINS IMPORTANT INFORMATION
Always enter the enclosure only through the
door of the net.High winds increase the
chance of a trampoline with enclosure being
blown over. Always secure your trampoline by
using an anchor kit. Adequate overhead
clearance is essential. A minimum of 24 ft
from the ground level is recommended.
Provide clearance for wires, trees, and other
obstacles. It is recommended for at least 2
able bodied adults to setup the trampoline net.
While every attempt is made to ensure the
highest degree of quality and protection in all
equipment, we cannot guarantee complete
exemption of injury. The user assumes all
responsibility of injury due to use of this
equipment. All merchandise is sold on this
condition, and all equipment is used at the
consumers risk.
Always inspect your trampoline and enclosure
before each use and regularly replace any
worn, defective, or damaged parts.
STEP 3
STEP 2
STEP 1
STEP 4
Start by tying a knot
through the V-ring closest
to the enclusure entrance.
Thread the rope through
the hole on the bottom of
the net and back into the
next V-Ring.
Continue till the rope ends
and tie off into a knot.
Repeat this process with
remaining ropes in star
shaped pattern to evenly
distribute the spacing of the
net. Do this along the length
of the Net, making sure the
Net is taught as you go along.
Remove the Top Ring
from the poles and
disassemble using a
screw driver and
adjustable wrench.
a) Unscrew Screw
from the underside of
the Top Ring Connec-
tor.
b) Use a wrence to
unscrew Top Ring Pole
Connector.
Once the Top Ring
pole is disconnected,
slide Top Ring
through Net Sleeve.
Continue to slide
the Top Ring Pole
through the Net
Sleeves until the
Top Ring is fully
through all of the
Net Sleeves.
Connect the Top
Ring Poles together
by screwing on the
connector. Screw in
the screw on
underside of the
connector to lock it
into place.
Align the gap
between the Sleeves
with the Enclosure
Pole. Snap the Top
Ring into Enclosure
Pole Cap and lock
into place. Attach the
Top Ring to the
remaining Pole Caps.
TOOLS NEEDED:
Phillips Screw Driver
Adjustable Wrench
IMPORTANT SAFEGUARDS
LIABILITY
CARE AND MAINTENANCE
START
ROPE
1
2
3
4
5
6
78
END
ATTACHING THE TOP OF THE NET
ATTACHING THE BOTTOM OF THE NET
TOP RING
ENCLOSURE NET ROPE x8
Read the following
instructions and warning to
ensure the trampoline is
safe to use and lasts as long
as possible, follow all
assembly and maintenance
instructions at all times.
STEP 2