skyvoe NXG-42 User manual

Table Stand
Installation
NXG-42 / NXG-46
*This Installation requires a minimum of two people.

2All Rights Reserved. 2017 SkyVue®
Installation Manual - Table Swivel Stand
Warning: Do not plug speaker bar into A/C outlet until connections to the
television have been plugged in. This will severely damage the speaker bar
if not followed completely.
Lay television down, viewing side down on blanket.
Lay blanket down on at sturdy
surface. Run hand over sur-
face to make sure there are no
sharp object or protrusions,
when the television is laying
down.

3
InstallatIon ManualnXG 42 / nXG 46 |
Remove 2 - M6X12 screws and washers, indicated with red circles.
STAND SWIVEL
NXG 4650 Use the Top Holes
NXG-4250 Use the Bottom Holes

4All Rights Reserved. 2017 SkyVue®
Installation Manual - Table Swivel Stand
Reinsert the screws with the at washers and tighten securely.
Align the holes of the table stand swivel uprights with the holes on the
back of the television.

5
InstallatIon ManualnXG 42 / nXG 46 |
Place mounting plate on your tabletop. Use 4 holes indicated in the red
circles to drill holes in your table top surface. Insert the fasteners that you
have purchased and tighten securely.
Place plastic cover on the mounting plate and press corners.

6All Rights Reserved. 2017 SkyVue®
Installation Manual - Table Swivel Stand
The main bolt for your SkyVue table stand is shipped with a protective
coating on it. At this time please remove.
Have your friend assist you with placing the television on the stand and
apply washers and nut as follows.

7
InstallatIon ManualnXG 42 / nXG 46 |
Place the provided plastic spacer
on the bolt shaft.
Followed by the provided
Stainless Steel Washer
Place the provided
Stainless Steel Lock Washer
Then completed with the
provided Stainless Steel Nut.
Be sure not to over tighten.

8All Rights Reserved. 2017 SkyVue®
Installation Manual - Table Swivel Stand
On the back of your table stand - Insert and secure the torque screw with
plastic spacer.

Congratulations you have successfully installed your table
stand. If you have any questions call our tech support team
(877)-475-9883 option 2