Smaair WGS-484CL User manual
SAFETY GUIDELINES:
Mounng Bracket
Downrod
Canopy
Screws
Hairclip Pin
Clevis Pin
Fan Motor Assembly
Light Kit
Glass Shade
Blades
Setscrew
Wall Control
Setscrew
4 pcs
Expansion
Screw
4 pcs
Setscrew stopper
4 pcs
Witing cap
3pcs
Setscrew
2 pcs
Screw
washesr
2 pcs
Screw spring
washer
2 pcs
Balance Pack
1 pc
OFF
OFF
Fabric
washesr
13 pcs
Screws
for Blades
13pcs
Nuts
Washesr
15
1 )Use screws for blade and fabric washers to attach the blade holder to the motor assembly.
1) 2) 3) 4)
1)Remove clamp pin (1) and
nuts
(2),
washesr
(3), cross pin (4) from
fan motor assembly
(5).
2)Place downrod assembly (2) into canopy (1) . Feed motor wires through the downrod assembly (2).
3)Feed motor lead wires through downrod/canopy assembly .
4)Place insert downrod into downrod yoke. Make sure to align hole in downrod with the hole in downrod
yoke. Install yoke cross pin (1) through yoke and downrod. Insert the
washesr
(4) into the cross pin
and lock it with the
nuts
(3) .Insert clamp pin (2) into cross pin until it snaps into place. Tighten set
INSTALLING THE BLADE
1)
1
4
5
23
1
2
12
3
4
5
screws (3) in yoke.
1
2
Carefully lift fan assembly onto mounting bracket.
Rotate fan until notch on downrod ball (1) engages
the ridge on the mounting bracket (2).
This will allow for hands free wiring.
Live
Neutral
Ground
Wall Switch
Wall
Outlet Box
Blue Wire
Black Wire
Ceiling
Outlet Box
Blue Wire
Black Wire
Black
Blue
White
Green
FAN
Neutral Wire (White)
Gtounding Wire (Green)
Neutral Wire (White)
Gtounding Wire (Green)
Live Wire (Black)
INSTALLING THE LIGHT KIT
INSTALLING THE CANOPY
Loosen the 2 screws on the bottom of mounting
bracket but do not remove them. Raise the
canopy up and align the keyholes on the bottom
of the canopy with the 2 screws on the bottom of
mounting bracket. Rotate the canopy until both
screws from the mounting bracket drop into the
slot recesses. Tighten screws securely.
blue white
black white
X3
1.
. Align the keyholes on the light kit to the screws on the motor assembly .Rotate the light kit until both screws
from the motor assembly drop into the slot recesses. Tighten the other one screw securely.
2.Connect the single pin wire from the light kit to the motor.
- blue to black
- white to white
3.Place glass shade on light kit and rotate until secure.
3
12
OFF
This manual suits for next models
1
Table of contents
