Smart series Amoresol Sol Classic User manual

The Smart Series Pte Ltd
39 Woodlands Close #08-62 Singapore 737856
8711 6780/ 8824 0463
Automated
Laundry
Rack
Product manual
Specifications
Sol Classic
Sol Pro
Lighting power: 12 – 32 W
Lifting motor (D.C): 50 W
Operating voltage: 220V, 50Hz
-
Drying power: 450W x2
-
Heating temperature: 40 – 50
degrees
-
Air drying power: 15W x 2
-
UV disinfection power: 3 – 8W
Load capacity: 35kg
Drop distance: 120cm
1. Machine cover
2. Machine
3. LED light
4. Telescopic arm
5. Wire rope
6. Drying poles
7. Connecting piece
8. Bracket
9. Sterilising lamp
10. Automated infrared sensor
11. Air drying
Sol Classic
120 cm
34 cm
8.6 cm
55 cm
135 - 250 cm
25 cm
Product Dimensions
Sol Pro
141 cm
36 cm
9 cm
56 cm
142 - 235 cm
25 cm
* Image is for illustration only, Please refer to actual product.* Image is for illustration only, Please refer to actual product.

Sol Classic Sol Pro
Remote Control
1. Light signal
2. Up
3. Sound
4. Down
5. Off
6. Solar heat drying
7. Light
Your laundry rack remote control has been paired and
requires no additional setup. If the remote control
indicator light is off, please check if the battery needs
replacement by removing the back cover.
If you are using a new remote control, you will need to
complete the pairing process before usage.
To do this, turn off the main power supply of your
laundry rack for at least 15 seconds, then turn it
back on.
Within 2 seconds, press and hold both "up" and
"stop" (Sol Classic) / "up" and "down" (Sol Pro) /
until you hear a beeping sound from the laundry
rack. Once you hear the beeping sound, the pairing
process is complete, and your new remote control
is ready for use.
8. UV Steriliser
9. Fan
10. Stop
11. Automated infrared sensor
12. Reduce brightness
13. Increase brightness
Command
Prompt tone
Remarks
Hey Sol
Hello, I'm glad to be of
service
/
Turn on light
/
/
Turn off light
/
/
Turn on fan
/
/
Turn off fan
/
/
Turn on solar drying
/
/
Turn off solar drying
/
/
Turn on steriliser
/
/
Turn off steriliser
/
/
Bring me up
/
/
Bring me down
/
/
Stop the rack
/
/
Turn on sound
Voice enabled
/
Turn off sound
Voice disabled
Turn off all sounds
Turn off everything
/
/
Volume up
The volume has
increased
This is the max
volume
Volume down
The volume has been
reduced
This is the min
volume
There are no voice
commands in 30
seconds
Goodbye
Exit voice control
mode
Voice Control
Please read the instruction manual for the correct usage of the
voice control feature.
It is important to enunciate clearly and speak at a sufficient
volume for the laundry rack to recognise your commands
accurately.
To ensure optimal performance, please use the voice control
feature in a quiet environment, and speak at a normal
conversational pace.
When Automatic Infrared
Sensor Is Enabled
Press the "auto" button to enable or disable the sensor function.
The LED light on the laundry rack will turn on when the sensor
detects human movement, and turn off after 1 minute when no motion
is detected.
Gently lift the laundry rack to activate automatic ascending when the
poles are in a stationary position.
(Sol Classic) Press the "+ light" and "- light" to adjust brightness.
(Sol Pro) Press and hold "light" for 2 seconds until the red indicator
light on the remote flashes. Use "up" and "down" to adjust light
intensity.
Lower poles from the original position at the top:
(Sol Classic) At the desired position, press "stop" and "+ light",
you will hear two beeps when the setup is successful.
(Sol Pro) At the desired position, press "stop" and "down", you will
hear two beeps when the setup is successful.
Repeat the above steps to set another position.
UV sterilising will turn off when it detects motion and turn back on
again after 10 seconds of no motion detected. It will also turn off
after 30 mins of operation.
Press "UV" again to manually turn the function on or off.
Auto infrared sensor
Automatic lighting
One-touch lift
Adjust light intensity
Laundry poles position memory
UV steriliser
Safety Function
Clear the area around the laundry rack before operating it.
If the pole encounters an obstacle when ascending, a beep will sound
and the rack will come to a halt.
If the pole encounters an obstacle while lowering, a beep will sound
and the rack will stop. The rack will then raise by 10cm.
Do not exceed 35kg weight limit.
If the weight exceeds the limit, a beep will sound and the rack will
remain stationary.
Lighting/fan drying/solar heat drying functions will turn off
automatically after 2 hours.
UV sterilising will turn off automatically after 30 minutes. Press the
button to start again when required.
Obstacle detection
Overload protection
Auto-off
Applicable For Sol Pro only