EZYmount SLT-510 User manual

SLT-510 manual.indd 2-3 10/08/12 1:23 PM
Installation Instructions
Tilting Wall Mount
CAUTION: DO NOT EXCEED THE
MAXIMUM STATED WEIGHT CAPACITY.
SERIOUS INJURY OR PROPERTY
DAMAGE MAY OCCUR!
200x200 / 300x300
400x200 / 400x400
55”
MAX 70kg
SLT-510
Use the tilt adjusting knobs to adjust your TV to the desired angle.
Maintenance
➔Check that the bracket is secure and safe to use at regular intervals
(at least every three months).
➔Please contact your local distributor if you have any questions.
4. Adjustment

➔Do not commence installation until you have read and understood the instructions
and warnings contained in this installation sheet. If you have any questions
regarding any of the instructions or warnings, please contact your place
of purchase.
➔This mounting bracket was designed to be installed and utilised ONLY as
specied in this manual. Improper installation or use of this product may
cause damage or serious injury.
➔This product should only be installed by someone of good mechanical ability,
with basic building experience and full understanding of this manual.
➔Make sure that the supporting surface (i.e. wall) will safely support the combined
load of this bracket and all attached hardware (TV) and components.
➔If mounting to timber wall studs, make sure that the mounting screws are
anchored into the centre of the studs. Use of a stud nder is highly recommended.
➔Always use an assistant or mechanical lifting equipment to safely lift and position
equipment.
➔Tighten screws rmly, but do not over tighten. Over tightening can cause damage,
greatly reducing their holding power.
➔This product is intended for indoor use only. Using this product outdoors
could lead to product failure and personal injury.
WARNING
IMPORTANT: Ensure that you have received all parts according to the component checklist prior
to installation. If any parts are missing or faulty, contact your local distributor for assistance.
Wall plate (x1)
A
Left adapter
bracket (x1)
B
Right adapter
bracket (x1)
C
NOTE: Please read the entire instruction manual before you start
installation and assembly
Component Checklist
SLT-510 manual.indd 2-3SLT-510 manual.indd 2-3 10/08/12 1:23 PM10/08/12 1:23 PM
ST6.3x55 (x6)
W-A
Concrete anchor (x6)
W-B
D8 washer (x6)
W-C

Find and mark the
exact location of
mounting holes.
Mark the exact
location of
mounting holes.
Drill pilot
holes.
Drill pilot
holes.
Screw the
wall plate
onto the
wall.
Screw the
wall plate
onto the
wall.
WARNING
WARNING
➔Make sure that mounting screws are anchored into the centre of the studs.
Use of a stud nder is highly recommended.
➔Installers are responsible to provide hardware for other types of mounting situations.
➔The installer must verify that the supporting surface will safely support the
combined load of the equipment and all attached hardware (TV) and components.
➔When installing wall mounts on cinder block, verify the actual concrete thickness
is at least 35mm for using the concrete anchors. Do not drill into mortar joints! Be
sure to mount in a solid part of the block, generally 25mm minimum from the side
of the block. It is suggested to use the electric drill on a slow setting to drill the hole
instead of a hammer drill to avoid breaking out the back of the hole when entering
a void or cavity.
➔The installer must verify that the supporting surface will safely support the
combined load of the equipment and all attached hardware (TV) and components.
1a. Mounting on Timber Stud Walls 1b: Mounting on Solid Brick and Concrete Block
SLT-510 manual.indd 4-5SLT-510 manual.indd 4-5 10/08/12 1:23 PM10/08/12 1:23 PM

Top of TV
Hook the TV onto the upper ridge of the wall plate. Tighten the safety screws using
a Phillips screwdriver to secure the TV to the lower ridge of the wall plate.
Important: Make sure the TV is correctly hooked onto the wall plate and the safety
screws are locked safely before releasing the TV.
2. Attach Adapter Brackets
3. Hang TV on the Wall Plate
➔Position the adapter brackets as close as possible to the middle of the screen.
➔Ensure the Tilt Adjusting Knobs are located on the outside of the rails.
➔Screw the adapter brackets onto the TV.
Tighten all screws, but do not over tighten.
SLT-510 manual.indd 6-7SLT-510 manual.indd 6-7 10/08/12 1:23 PM10/08/12 1:23 PM
M-A
M-B
M-F
M-C
M-D
M-C
M-D
M-F
M-C
M-D
M-F M-F
M-H
M-H
M-H
M-H
M-H
M-G M-G
M-G
M-H
M-H
M-H
M-H
M-G
M-G
M-G
M-F
M-F
M-F
M-E
M-E
M-E