
smarttech.com/kb/171363
5 sec
10 mm (3/8")
A
B
15
16
*102xxxx*
1032686 Rev 02
© 2019 SMART Technologies ULC. All rights reserved. SMART Board, smarttech, the SMART logo and all SMART taglines are trademarks or
registered trademarks of SMART Technologies ULC in the U.S. and/or other countries. All third-party products and company names may be
trademarks of their respective owners. Contents are subject to change without notice. This product and/or use thereof covered by one or more
of the following U.S. patents; smarttech.com/patents. Other patents pending. 04/2019.
support.smarttech.com/support
support.smarttech.com/contact-support
Hardware environmental compliance
SMART Technologies supports global efforts to ensure that electronic equipment is manufactured, sold and disposed of in a safe and environmentally friendly manner.
Waste Electrical and Electronic Equipment (WEEE)
Electrical and electronic equipment and batteries contain substances that can be harmful to the environment and to human health. The crossed-out wheeled bin symbol indicates
that products should be disposed of in the appropriate recycling stream and not as regular waste.See smarttech.com/compliance for more information.
Warning: Operation of this equipment in a residential environment could cause radio interference.
FCC
Suppliers Declaration of Conformity 47 CFR § 2.1077 Compliance Information • Unique Identifier: WSE-400
Responsible Party – U.S. Contact Information: SMART Technologies Inc. 1505 Westlake Ave N, Suite 700, Seattle, WA 98109
FCC Compliance statement
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference,
and (2) this device must accept any interference received, including interference that may cause undesired operation.
Innovation, Science and Economic Development Canada (ISED)
This device complies with ICES-003 of the ISED rules. Operation is
subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including
interference that may cause undesired operation.
Cet appareil est conforme à la norme ISED NBM-003 pour les appareils radio
agréés. Son fonctionnement est sujet aux deux conditions suivantes:
(1) le dispositif ne doit pas produire de brouillage préjudiciable, et
(2) ce dispositif doit accepter tout brouillage reçu, y compris un brouillage
susceptible de provoquer un fonctionnement indésirable.
Was this document helpful?
smarttech.com/docfeedback/171363
Installation and maintenance guide
smarttech.com/kb/171372