SmartRG MC20 User manual

Quick Start Guide
MC20
This Quick Start Guide shows you how to set up and begin using
your new adapter.

INSTALLATION
The MC20 adapter is installed between the incoming coaxial wall jack
and the destination device, such as a TV or a set-top box.
Connect a coax cable to the cable wall jack and to the
MoCA®IN port on the adapter.
Connect an Ethernet cable to your set-top box and to the
Ethernet port of the adapter.
Connect the power adapter to a wall outlet and then to the
DC 5V port on the adapter. Press the ON/OFF button.
If you cannot access your services, verify all cables are securely
connected.

ON/OFF
MoCA® IN
TV OUT ETHERNET RESET DC SV
2
1
3
3

LED INDICATORS
The LEDs on the top of the MC20
can help you understand the
current state of your adapter.
Legend: Green Green blinking White White blinking
LED Action Explanation
Power Adapter has power
Ethernet Ethernet is connected
Data being transmitted
MoCA®MoCA is available
Data being transmitted

OPTIONAL WALL MOUNT
Insert the two included screws into the wall using the template
below. Using wall anchors is recommended.
Slide the adapter down on the screws.
2 1/2” (64 mm)
1/16” (2-3mm) Wall Anchor
5

ADDITIONAL SUPPORT
If you require further instructions, please contact your local ISP Support.
SMARTRG INC. ALL RIGHTS RESERVED. COPYRIGHT 2017 ©