6
2. Transport
a) Hitch up the trailer to the car and
preparing vehicles for transport.
To hook the handle to the hook
should be imposed on the tiller handle
hook the car with raised lever F.
properly hooked to the hook holder
green color indicates the ratio A on
the head of the handle and lever F
max pressed down. Circle
maneuvering B unscrew the drawbar
and put in the boot of the car. Power
plug lights D placed in the socket of
the car. Secure the handbrake in the
car and throw gear. Send down the
trailer handbrake C (brake levers leave downwards)
We make sure that four valves of cylinders Zare closed (lever Za horizontal position). Check the clearance under
the trailer and that the cylinders Zare correctly folded. Inspect: fixing tilts and supports S, correct tire pressure
(3.5 bar), the correct fastening of wheels (Tightening torques for screws 110 Nm). The standard hook height from
the ground to the top of the head should be between 42-46 cm. This height ensures that the trailer will have
adequate clearance between the ground and the frame and will not occur in the overhang of the trailer. Check the
tire condition. We make sure that all lights are working properly and that the load inside the trailer is stable and
properly fastened (according to the manual disassembly stage). Thus prepared, the set is ready for transport.
Speed set of vehicles to be adapted to prevailing road conditions such as weather conditions (wind speed,
precipitation) or the state of the road surface but speed should not be higher than 70 km / h
b) Before traveling check that:
-have a driving license category B + E,
-Does your car is equipped to tow a trailer with a maximum mass
-whether you have current insurance, and a MOT of the trailer and car
