SnapNrack SpeedSeal 242-05164 User manual

Technical Specifications
Material SnapNrack SpeedSeal™ Foot: A380 Aluminum
Conduit Hanger: Zinc-Plated Steel (¾” or 1”)
#14 x 2¼” Wood Screw: Stainless Steel
Compatibility ¾” or 1” EMT Conduit; Steep Slope composition
shingle roofs 9½° or greater, rolled comp
or other compatible Low Slope roofs when
appropriate
SpeedSealTM Conduit Support Installation Manual
snapnrack.com
1
Conduit Mount Assemblies
SpeedSeal™ Conduit Mount Kit, ¾" EMT - 242-05164
SpeedSeal™ Conduit Mount Kit, 1" EMT - 242-05165



Materials Included
(1) SnapNrack SpeedSeal™ Foot
(1) EMT Conduit Hanger (¾" or 1”)
(1) SnapNrack Sealing Wood Screw #14 x 2¼”
3.05
2.58 3.20
4.53
SpeedSeal™ Conduit Mount Kit Dimensioned



Required Tools
Impact Driver ½” Socket 7/16” Socket or Phillips Bit
Tape Measure Roofing Sealant
Install Instructions
Determine location of
conduit supports based on
conduit run and mark roof
surface if desired.
snapnrack.com
Using an impact driver & 1/2” socket
drive the #14 wood screw into the
roof decking until the EPDM washer
under the hex head begins to push
out the sides of the fastener.
Turn the SpeedSeal™ Conduit
Support over & fill the sealant dam
on the bottom of the SpeedSeal™
Foot with sealant.
4
2
Place the SpeedSeal™ Conduit
Support onto the roof surface in
desired location. Support can be
oriented in any direction.
3
Design Note
Conduit support locations shall meet
the requirements of NEC Article 358,
and should not exceed 10’ between
supports or 3’ from enclosures.
1
Important
The SpeedSeal™ Conduit Mount must
be installed immediately after filling
with sealant before the sealant skins
over.
Important
The foam gasket on the bottom of
the SpeedSeal™ Conduit Support
must be installed on only one shingle
course & shall not overlap courses
N-S.
Important
When installed correctly there should
be sealant expelled from the vent in
the foam sealant dam.
Place conduit into the support strap
and tighten hardware until conduit
is secure.
5
Design Note
The minimum height EMT must be
above the roof surface is 7/8” per
NEC 310.15(B)(2). Pay close attention
to this when routing EMT over ridges
or through valleys in the roof.
The SnapNrack name and SnapNrack logo are the property of SnapNrack, Inc.
All information contained in this document are the property of SnapNrack, Inc.
©2022, SnapNrack, Inc. All rights reserved.
877-732-2860 www.snapnrack.com [e-mail]