SNOWJOE SUNJOE 24V-X2-17LM Setup guide

7/21/2022 24V-X2-17LM Blade Tighten Rework Revision: 000
Consumer Inspection and Repair Instructions
The Hazard: the mower blade can detach unexpectedly, posing a laceration hazard.
Goal: Ensure that lawn mower blade is secured in place to manufacturer's specifications
Tools Needed: Ratchet Wrench
Training Needed: Basic familiarity with hand tools. Please contact Snow Joe at 800-641-2917 or by email
at [email protected] if you have any questions regarding the inspection and repair or if you would
like assistance in finding a repair center that can provide this service at no cost to you.
Time Needed: Approximately 5 Minutes
1. /!\ WARNING Read, understand, and follow all instructions before starting to repair the mower.
2. Disconnect the lawn mower –Turn OFF and REMOVE the batteries and the safety key before
inspecting the mower.
3. Only responsible adults who are familiar with the instructions should be allowed to repair this
machine.
4. Keep children, bystanders, and pets away –Always keep children and spectators a safe distance
away from the mower during this inspection.
5. Dress properly –Always wear personal safety gear (i.e. glasses, rubber gloves, and protective
footwear) and proper clothing when inspecting the mower. Loose clothing, long hair or jewelry
may get caught in the moving parts.
6. Stay alert –Always be alert and watch what you are doing. Use common sense. Do not perform
this operation with the lawn mower when you are tired or under the influence of alcohol or
drugs.
7. Mower blade is sharp. Wrap the blade or wear gloves and use extra caution when servicing it.
Mower Inspection and Repair
Please contact Snow Joe at 800-641-2917 if you have any questions regarding the inspection and
repair or if you would like assistance in finding a repair center that can provide this service at no cost
to you.
1. Disconnect the lawn mower –Turn OFF (see Item 23 in image below) and REMOVE the batteries
(see Item 14 in image below) and the safety key (see Item 15 in image below) before inspecting
the mower.

7/21/2022 24V-X2-17LM Blade Tighten Rework Revision: 000
On-Off Switch
2. Carefully turn the mower upside down.
Safety Key

7/21/2022 24V-X2-17LM Blade Tighten Rework Revision: 000
3. Inspect the mower blade and ensure the lug nut, lock washer, plastic carrier, and blade are all in
place as shown in Fig. 15.
4. Tighten the lug nut until snug using a Ratchet Wrench by turning the wrench clockwise until the
lug nut is snug against the lock washer using one hand to tighten until you cannot tighten
further.
5. Review user manual instructions before using the product.
Lock Washer
Plastic Carrier
16 mm Ratchet
Wrench