manuals.online logo
Brands
  1. Home
  2. •
  3. Brands
  4. •
  5. Snowsport
  6. •
  7. Snow Blower Accessories
  8. •
  9. Snowsport DOWN PRESSURE KIT User manual

Snowsport DOWN PRESSURE KIT User manual

REQUIREMENT: SNOWSPORT®HD or LT Utility Plow
with SNOWSPORT™ Electric Plow Winch.
!WARNING: Do not apply down pressure when
stacking snow or damage to vehicle may occur.
!CAUTION:Excessive down pressure may cause
damage to surfaces and wear on rubber cutting edge.
SAFETY INFORMATION
• Always follow safety information in SNOWSPORT®Utility
Plow and Electric Winch’s standard instructions
OPERATING INSTRUCTIONS
• For no down pressure, lower blade until you feel or hear
plow contact the ground
• For down pressure, continue to lower blade until front of
vehicle begins to rise
DOWN PRESSURE KIT
102519 2000272_A
• Assists in removal of drifted,
compacted snow
• Quick and easy installation
DOWN PRESSURE KIT INSTRUCTIONS
See inside for instructions
Reorder #4003912
Cancer and Reproductive Harm
www.P65Warnings.ca.gov
WARNING:
!WARNING:Disconnect quick connect plugs before
installing down pressure kit.
A. Ensure blade is in plow position and winch’s synthetic
cable is attached to cleat. Next, remove (2) bow-tie pins
and winch cover.
B. Insert down pressure kit’s synthetic cable through
notched hole in left side of motor shaft. Secure with over
hand knot then pull on synthetic cable until knot recesses
in motor shaft.
C. Wrap down pressure kit’s synthetic cable twice around
motor shaft following notch in hole.
D. Reattach winch cover with (2) bow-tie pins.
INSTRUCTIONS
Notch
Two full
wraps
Notched hole
in motor shaft
Over hand knot
E. Attach carabiners to each end of down pressure
strap then slide one carabiner through down
pressure kit’s synthetic cable loop.
NOTE:Down pressure strap is shown yellow for
illustration purposes.
Down pressure
kit’s synthetic
cable loop
Carabiners
Behind
and under
push
frame
Carabiner
attached to
slide hinge
F. Run down pressure strap behind and under
push frame then up between push frame and
blade. Attach carabiner to slide hinge.
G. Repeat Step G for opposite side.
H. Reconnect quick connect plugs and practice
applying down pressure before you plow to
understand how components interact.
Up between
push frame
and blade

Popular Snow Blower Accessories manuals by other brands

Briggs & Stratton 1696092-00 Operator's manual

Briggs & Stratton

Briggs & Stratton 1696092-00 Operator's manual

LOFTNESS 481EFT Operator's manual / parts book

LOFTNESS

LOFTNESS 481EFT Operator's manual / parts book

Boss Snowplow BRX25175 owner's manual

Boss Snowplow

Boss Snowplow BRX25175 owner's manual

Toro 108-7317 installation instructions

Toro

Toro 108-7317 installation instructions

Meyer TRIMLINE Series Operation and maintenance manual

Meyer

Meyer TRIMLINE Series Operation and maintenance manual

manuals.online logo
manuals.online logoBrands
  • About & Mission
  • Contact us
  • Privacy Policy
  • Terms and Conditions

Copyright 2025 Manuals.Online. All Rights Reserved.