SOKOYO CAPSOL KY-Y-YY-001 User manual

Installation Manual For CAPSOL
All In One Solar Garden Light
1. Instruction
This model includes solar panel, lithium battery, controller and LED light source.
You can assembly it easily according to the product label.
2.Application
Mainly used for lighting in public places such as countryside roads, branch roads, family
yards, tourism areas, parking lots, parks and public squares.
KY-Y-YY-001
Light Source
Solar Panel
Rated Power
10W
Color Temperature
6000K
Light Efficiency
110LM/W
CRI
Ra≥70
Working Environment
-10 ℃～ +60 ℃
Lamp Dimension
660x189x67mm
IP Rate
IP65
5V/17W Mono PV
3. Specification
4. Installation Process
Model No.
Lamp Photo
Lithium Battery
LiFePO4 3.2V/30AH
Lamp Weight
Packing Dimension
3.75KG
711x117x240mm
1 2 34
S OKO Y O
Light up every road back home
Bridgelux 3030
1. Drill 2 φ9mm holes
on a wall, as
selected;
2. Ensure that the
selected location has
sufficient sunlight.
Punch two φ8mm
expansion Bolts into
the holes and lock
them tightly.
Align the mounting holes
of the base with the
expansion Bolts and put
the Bolts in. Secure the
Bolts with washers and
nuts in the following
sequence: flat washers,
spring washers and finally
nuts. Tighten.
Installation is completed
after the above steps.
φ8mm
expansion Bolts
φ8mm
expansion Bolts
Connect the lamp to the support arm.
12
34
Put on the screws and tighten them .
Place the arm hoop tightly on
the position to be installed,
then align the other hoop with
the hoop on the arm, and lock
it with screws.
Installation is completed after
the above steps.
Installation process for Wall-mounted CAPSOL.
Installation process for CAPSOL with arm.

SOKOYO reserves the right to improve the product. We will not
notify if this product is improved in the future.
1. The product must be properly packaged while transportation to avoid collisions;
2. The controller debugging should be operated in accordance with the manufacturer's
instruction book;
3. The working voltage of this type of lamp was designed based on the product specification
showed on the product label, changing this voltage will cause damage to the product;
4. The maintenance or replacement of lamps requires qualified persons to replace them to
avoid danger;
5. The installation location should avoid all kind of shades obstructions, such as high buildings,
trees, wires, etc., ensure that the solar is facing to a sufficient sunlight;
6. If the product has not been used for more than three months, it should be recharged for two
days under sufficient sunshine before use to ensure the best performance of the product;
7. In areas with less rain, it is recommended that the panels get cleaned once a month, as well
as the areas with large amount of dust fall, clean the solar panel more frequently in the dusty
places according to the level of dust.
5. Precautions:
Indicator Signal Explanations:
1. Constantly ON, indicating that the battery is working normally and/or the LED light
source is ON
2. OFF, indicating that the battery is not working or the system was switched OFF
3. Slow flashing, indicating that the system is charging
4. Fast flashing, indicating that the system is malfunctioning (battery over-discharge or
over-voltage)
Note: Before use, put the lamp under the sun, illuminate the Solar Panel directly to
activate the light source board, or use the supplied remote control to start. After the light
source indicator flashes slowly to charge, then begin the installation.