Sonance SONANCE ARCHITECTURAL SERIES AS38RS User manual

Remove the paint shield from the finished
mounting platform.
Cut the four tabs on the sanding shield support
structure in the speaker bracket. NOTE: The
speaker wire is connected to the zip tie for
easy access.
Remove sanding shield support. Remove zip tie
from speaker wire.
1
3
2
When using AS38RS/BPS6 or AS68RS/BPS8
System, switch to high pass ON. High pass
switch is located on the back of the crossover
cover. Switch high pass to OFF when choosing full
range and no BPS6 or BPS8.
4
With Bandpass
Subwoofer
(1) Quickstart guide
(1) AS speaker
(1) Round grille
(1) Square grille
(1) Grille painting instructions
(1) Set of speaker screws w/ Loctite®
Box Contents
AS38RS AND AS68RS (ROUND AND SQUARE)
QUICKSTART GUIDE
SONANCE ARCHITECTURAL SERIES®

©2014 Sonance. All rights reserved.
Sonance and Architectural Series are registered trademarks of Dana Innovations.
Due to continuous product improvement, all features and specifications are subject to change without notice.
For the latest Sonance product specification information, visit our website: www.sonance.com
SONANCE • 212 Avenida Fabricante • San Clemente, CA 92672-7531 USA
[phone] or [phone] • FAX: [phone] • Technical Support: [phone]
www.sonance.com
04.25.1433-5948
Apply Loctite® to screws and screw speaker to
mounting platform.
The leveling ring is for fine adjustment.
If necessary adjust the magnetic grille leveling
ring with a screwdriver and install magnetic grille.
See grille painting instructions.
6
7
Connect the negative wire to the black spring
terminal and the positive wire to the red
spring terminal.
5
For wiring diagrams and detailed eManual scan the
QR code or visit www.sonance.com/in-wall-in-ceiling/
architectural-series