SONIK RC AVIATOR 400 User manual

Aviator 400

2 / 12

3 / 12

4 / 12
The Aviator 400 comes with a pre-installed Gyro to
make your flying experience easy. To turn On the
Gyro, pull the toggle switch towards you for fully
assisted flight. Push the toggle switch away to turn
Off, the middle position is partial Gyro assist.
CAUTION: It is strongly recommended to turn the
Gyro On while flying the Aviator 400 for the first
flight.
Note: Allow the Aviator 400 to stay still for about
5-10 seconds in a calm enviroment when being
turned On. This allows the Gyro to calibrate.

5 / 12
3.Bind the transmitter with the plane
4. Center control surfaces

6 / 12

7 / 12
Channels Reactions Checking Gyro Test
Place your plane in a neutral position, follow below steps to check the channels
reactions.
Move the sticks(except the throttle stick) to see if all servo surfaces react correctly as
shown in the left diagram(left throttle for example).
Swing your plane to check if all servo surfaces react correctly as shown in the right
diagram.
Swing The
Plane Reaction
Transmitter
Operaton Reaction

8 / 12
WARNING: Normally this function is not necessary to be operated. Only operate
the above steps when you understand completely of the channel reverse function.
WARNING: Do NOT reverse throttle otherwise serious damage would probably
cause!
1.Turn the throttle stick to min position.
2.Power on the Transmitter and the receiver.
3.Do NOT unlock the throttle.
4.Turn the channel stick to max position of any side and hold for several seconds.
5. When you hear a “beep” sound, it means the channel is reversed.

9 / 12

10 / 12

11 / 12